Search
Search Results
-
Projection of the Airborne CO2 Concentration by Land/Ocean Absorption Dynamics and Fossil-Fuel Reserve Depletion
The paper has been suggested by the following observations: (1) the atmospheric growth rate of carbon dioxide concentration is smaller than that...
-
High pressure suppression of plasticity due to an overabundance of shear embryo formation
High pressure shear band formation is a critical phenomenon in energetic materials due to its influence on both mechanical strength and...
-
SsL-VGMM: A Semisupervised Machine Learning Model of Multisource Data Fusion for Lithology Prediction
In deep mineral exploration, it is difficult to constrain the complex geological structures using a single geophysical method. To tackle the...
-
Interfacial microstructure and electrochemical behavior of diffusion welded joints of Zr-Alloy and super duplex stainless steel
In this study, solid-state diffusion welded joints of zirconium alloy (Zr-Alloy) and super duplex stainless steel (SS) were prepared at 875 °C with...
-
A Molecular Dynamics Study on the Adhesive Contact with Effect of Tangential Forces
Adhesive contact with the effect of tangential force may have important implications in friction and wear performances of small-sized devices and...
-
Dynamics of a linear source epidemic system with diffusion and media impact
This paper studies an impact of media epidemic system with diffusion and linear source. We first derive the uniform bounds of solutions to impact on...
-
Effects of Different Concentrations of Weak Acid Fracturing Fluid on the Microstructure of Coal
As a crucial factor that influences the hydraulic fracturing effectiveness of coal seams, fracturing fluids have garnered increasing attention. Among...
-
Study of porous limestone mechanical behavior with digital image correlation: calibration and validation
This article deals with the monitoring of strain on tuffeau, a soft and porous building limestone used in stonework in historical masonry. Previous...
-
A note on structural mode transitions in buckling of radially stretched annular plates
The different approximating assumptions used in deriving models for structural analysis by dimensional reduction of a 3d continuum to structural...
-
Modeling cardiac microcirculation for the simulation of coronary flow and 3D myocardial perfusion
Accurate modeling of blood dynamics in the coronary microcirculation is a crucial step toward the clinical application of in silico methods for the...
-
Enhancing damage prediction in bulk metal forming through machine learning-assisted parameter identification
The open-source parameter identification tool ADAPT (A diversely applicable parameter identification Tool) is integrated with a machine...
-
Energy finite element model for predicting high frequency dynamic response of taper beams
Taper beams are widely used due to its good dam** properties in vibration and noise control field. For dynamic response analysis of taper beams in...
-
A discontinuous Galerkin/cohesive zone model approach for the computational modeling of fracture in geometrically exact slender beams
Slender beams are often employed as constituents in engineering materials and structures. Prior experiments on lattices of slender beams have...
-
Influence of delamination on uncertain dynamic characteristics of variable angle tow laminates using polynomial neural network
This paper presents the delamination impact over the dynamic response of the variable angle tow (VAT) composite plates. The VAT plates with various...
-
The uniaxial compressive strength of concrete: revisited
This paper re-examines common notions and conventions regarding the compressive strength of concrete in general and of the uniaxial compressive...
-
Experimental investigation on bond performance of UHPFRC wet joint by direct tension test
Ultra-high-performance fiber-reinforced concrete (UHPFRC) is applied to joint nodes with its excellent mechanical properties, which helps to improve...
-
Response to Shariff’s comments to my paper on his isotropic invariants (Shariff, 2023)
In the paper by Shariff (Q. J. Mech. Appl. Math. 76 , 143–161,
2023 ) a functional basis of vectors and symmetric tensors based on eigenvectors of the... -
CuMn2O4 spinel electrodes: effect of the hydrothermal treatment duration on electrochemical performance
CuMn 2 O 4 (CMO) thin films are produced using a simple hydrothermal method. The influence of reaction duration on the electrodes’ electrochemical...
-
Evolution of Broken Coal’s Permeability Characteristics under Cyclic Loading–Unloading Conditions
This study conducted a cyclic loading–unloading (CLU) test on broken coal samples with three particle sizes (0–5 mm, 5–10 mm, and 10–15 mm) under...
