-
Article
Correction to: A review of the effect of tungsten alloying on the microstructure and properties of steels
-
Article
Effects of magnetic field and hydrostatic pressure on the antiferromagnetic–ferromagnetic transition and magneto-functional properties in Hf1-xTaxFe2 alloys
In this study, the thermal expansion of Hf1-xTaxFe2 (x = 0.10, 0.13, 0.15) compounds by adjusting the Ta concentration was successfully regulated. The magnetocaloric properties, hydrostatic pressure affecting the...
-
Article
A review of the effect of tungsten alloying on the microstructure and properties of steels
With the continuous development of science and technology, the increasingly severe service environment makes people put forward higher requirements for the performance of alloy steel. Tungsten has unique prope...
-
Article
Effect of large load on the wear and corrosion behavior of high-strength EH47 hull steel in 3.5wt% NaCl solution with sand
To simulate the wear and corrosion behavior of high-strength EH47 hull steel in a complicated marine environment in which seawater, sea ice, and sea sand coexist, accelerated wear and corrosion tests were perf...
-
Article
Influence of hot rolling on microstructure and mechanical characteristics of explosive-welded FSS/CS laminate
The influence of hot rolling on the microstructure and subsequent mechanical characteristics of explosive-welded ferritic stainless steel (FSS)/carbon steel (CS) laminate was investigated. The results indicate...
-
Article
Effects of microrolling parameters on the microstructure and deformation behavior of pure copper
Microrolling experiments and uniaxial tensile tests of pure copper under different annealing conditions were carried out in this paper. The effects of grain size and reduction on non-uniform deformation, edge ...
-
Article
Stir casting process for manufacture of Al–SiC composites
Stir casting is an economical process for the fabrication of aluminum matrix composites. There are many parameters in this process, which affect the final microstructure and mechanical properties of the compo...
-
Article
Interface analysis and hot deformation behaviour of a novel laminated composite with high-Cr cast iron and low carbon steel prepared by hot compression bonding
A hot compression bonding process was developed to prepare a novel laminated composite consisting of high-Cr cast iron (HCCI) as the inner layer and low carbon steel (LCS) as the outer layers on a Gleeble 3500...
-
Article
Analysis of Fishscaling Resistance of Low Carbon Heavy Plate Steels
The precipitates and hydrogen permeation behavior in three kinds of hot rolled low carbon heavy plate steels for enameling were analyzed1 then, both sides of the steels were enameled. The uperimental results s...
-
Chapter and Conference Paper
Construction of China’s Monetary Condition Index Based on the STR Model
Based on China’s monthly data ranging from January 1996 to January 2012, using smooth transition regression model (STR), construct China’s nonlinear monetary condition index. The conclusion shows that the cons...
-
Article
Thermal, Microstructural and Mechanical Coupling Analysis Model for Flatness Change Prediction During Run-Out Table Cooling in Hot Strip Rolling
Non-uniformity of temperature distribution across strip width direction is the ultimate reason why the flatness defect occurs on the strip after cooling process although the strip is flat at the exit of finish...
-
Article
Allowable variation of cold-rolled strip transverse profiles in high tension
The formation mechanism of the cold-rolled strip shape with high tension was studied. An advanced method to calculate the allowable variation of strip transverse profiles was established by the strip buckling ...
-
Article
Effect of initial crown on shape of hot rolled strip
Based on the influence coefficient method, the effect of entry strip crown on the shape of hot rolled strip was analyzed using the software of roll elastic deformation simulation. According to the practical co...
