Search
Search Results
-
Charge Sensitive Amplifier with Pseudo-differential Output
AbstractThe design results of a charge-sensitive amplifier (CSA) with a pseudo-differential output are presented. The CSA is intended for operation...
-
Modeling a Broadband Amplifier on a Printed Circuit Board with an Increased Conductivity Dielectric
AbstractSpacecraft are affected by cosmic plasma electrons, which cause the electrification of their dielectric materials. As a result, electrostatic...
-
Noise in Operational Amplifier
This chapter describes noise in operational amplifierNoise in operational amplifier. Physically it is the differential amplifierDifferential...
-
Variation-Tolerant Sense Amplifier Using Decoupling Transistors for Enhanced SRAM Read Performance
A decoupled inverter pair sense amplifier (DIPSA) is proposed for improved sensing in differential SRAM. The DIPSA is designed at 45-nm technology...
-
2.2 Biasing the Basic Electronic Amplifier Configurations
In the previous Book of the LNAE series we talked about electronic components and their characteristics. The following is a discussion of basic...
-
DTMOS based four-quadrant multiplier/divider with voltage difference transconductance amplifier
In recent years, all portable gadgets must operate at low power in order to increase battery life, increase dependability, and lower the expense of...
-
A Fully-Differential Chopper Capacitively-Coupled Amplifier with High Input Impedance for Closed-Loop Neural Recording
In this paper, a chopper capacitively-coupled instrumentation amplifier (CCIA) with high input impedance and low input-referred noise is presented...
-
High-Sensitivity Transimpedance Amplifier for MEMS Microsensor Readout in Acetone Vapor Detection
The microelectromechanical systems (MEMS) technology has been successful in yielding high-performance sensors for the measurement of pressure,...
-
A switched-capacitor based track-and-hold amplifier suitable for PAM4 signaling in 45-nm CMOS
In this paper, we propose the design of a track and hold (T&H) integrated circuit that is able to sample an incoming high-speed PAM4 signal and feed...
-
Low-voltage dynamic comparator using positive feedback bulk effect on a floating inverter amplifier
This work presents the design of a low voltage dynamic comparator for low-power ADC applications. The dynamic comparator uses a pre-amplifier powered...
-
Radiation Hardened Components of Semicustom Analog Microcircuits
Abstract —An MH2XA031 master slice array (basic matrix crystal (BMC)) is applied for designing and semicustom production of analog integrated circuits...
-
Design Considerations for Low Noise Amplifier
Low Noise Amplifier is also commonly known as LNA. Radio receiver performance greatly depends on LNA. The various design considerations for LNA have...
-
Study of High Electron Mobility Transistor for Biological Sensors
In this chapter, we emphasize on High Electron Mobility Transistors for assistive medical technology. Our focus is on the application of HEMT-based...
-
A gain reconfigurable time difference amplifier with self-adaptive linearity control
Time difference amplifier (TDA) is often used in time domain interconnection, computing and measurement. Gain and linearity control are two main...
-
Voltage and Power Amplifiers
In this chapter, we discuss the design methods for typical transistor amplifiers, mainly for audio applications. Starting with a simple basic...
-
From 65 nm to 28 nm CMOS: design of analog building blocks of frontend channels for pixel sensors in high-energy physics experiments
The 28 nm CMOS process is the major commercial successor of the 65 nm one and widely used for the design of advanced application-specific integrated...
-
The Ideal Op-Amp
An operational amplifier (op-ampAmplifierop-amp) isOperational amplifierOp-amp aOp-amp special type of differential amplifier that has some very...
-
Non-linear Uses of Op-Amps
In the previous chapter, the op-amp was used as a linear amplifier. A real op-amp has limitations that can be exploited to make useful circuits in...
-
Junction Temperature Measurement Method for SiC MOSFET Based on Charge Variation
Reliable measurement of the junction temperature Tj is important for the safe operation and reliability assessment of power semiconductors. In this...
-
Adaptive composite bandwidth and automatic gain control receiver for 6G wireless optical communication
The advent of 6G communication promises a transformative leap in wireless connectivity, ushering in an era of unprecedented data rates, ultra-low...
