Search
Search Results
-
Family of boost and buck-boost converters with continuous input current and reduced semiconductor count for hybrid energy systems
Power converters are the key link to realize energy transfer from hybrid energy systems (HESs) to loads. In this paper, a family of boost and...
-
Quadratic-type high step-up DC–DC converter with continuous input current integrating coupled inductor and voltage multiplier for renewable energy applications
This paper presents a quadratic-type high step-up DC–DC converter for renewable energy applications with a continuous input current. To reduce the...
-
General Stabilization for Stochastic System With Input Delay and Multiplicative Noise: Continuous-time Case
This paper investigates the general stabilization issues for continuous-time stochastic dynamics whose input delay and multiplicative noise in...
-
A New High Gain Boost Converter with Common Ground for Solar-PV Application and Low Ripple Input Current
High gain DC-DC converters are needed to step up the low voltage generated from distributed generation (DG) sources. Many topologies of these...
-
Effective Electrical Fault Diagnosis Using Gabor Transform of Motor Input Current After Spectral Subtraction
In the present work, it is proposed to use stator current spectrum analysis by Gabor transform (GT) to identify electrical defects in induction...
-
Improved low-ripple input current high-step-up DC–DC converter with switched inductors
Aiming at solving the problem of the low output voltage of fuel cell systems, this paper proposes a new type of high-gain low-ripple passive clam**...
-
A New Type of Half-Bridge Trans-Z-Source Inverter with Continuous Input Current
Z -source inverters play a vital role in the conversion of dc voltage to ac. A new half-bridge-based impedance source inverter topology is proposed by...
-
Continuous Dynamics Distinguishability
In this chapter, we analyze the possibility of determining the current discrete state of an LH-system by using only the continuous output...
-
Method for Minimizing Static Current Consumption of Single Class Nonlinear Input Stages of Micro-power High-Speed Operational Amplifiers
The authors consider circuit design methods for designing class “AB” input differential stages (DSs) with local resistive negative feedback on a...
-
Numerical investigation on keyhole stability and weld pool dynamics during quasi-continuous laser beam welding of Ti6Al4V plate using constant and modulated high-frequency pulsed heat input
For numerical investigation of the quasi-continuous laser beam welding (Q-CLBW) process, the existing research usually considered a constant welding...
-
Novel Observer-Based Input-Constrained Control of Nonlinear Second-Order Systems with Stability Analysis: Experiment on Lever Arm
In this survey, the stability of input-constrained control for a widely used class of second-order systems is investigated. A continuous...
-
Voltage regulation of DC–DC boost converter with input filter: hybrid and embedded PWM control approaches
In this paper, two different active control approaches are proposed for a cascaded interconnection of a boost converter and an input filter. The...
-
Input-output Finite-time Stability of Switched Singular Continuous-time Systems
This paper is concerned with the problem of input-output finite-time stability (IO-FTS) for a class of switched singular continuous-time systems....
-
A continuous convolutional trainable filter for modelling unstructured data
Convolutional Neural Network (CNN) is one of the most important architectures in deep learning. The fundamental building block of a CNN is a...
-
Design of a welding power supply with wide input voltage range
This paper proposes a power supply for welding that can adapt to a wide range of input voltages. The phase-shifted full-bridge (PSFB) converter,...
-
Bifurcation of Double-Input DC–DC Buck Buck-Boost Fused Converter
The bifurcation behavior a double-input DC–DC buck buck-boost fused converter (DIBBFC) has been discussed in this paper. The considered converter is...
-
Position control of input-delayed mobile manipulator
This paper presents the design of a novel continuous robust controller for a nonholonomic mobile manipulator in the task space. The main objective of...
-
Interleaved step-down converter with capacitor-diode voltage splitter and minimum switches for low current ripple and extra-low voltage ratio
This paper proposes an interleaved step-down converter (ISDC) with a capacitor-diode voltage splitter. Even though the ISDC only utilizes two active...
-
Finite Time Fully Distributed Consensus Control for Multi-agent System With Input Saturation and Limited Communication Resources
A finite-time fully distributed consensus (FTFDC) control problem is studied for a second-order multi-agent system (MAS) with input saturation,...
-
Analysis and design of a current suppressor to mitigate the inrush current for a low-voltage DC distribution network
This paper aims to analyze the inrush load current and develop an inrush current suppressor circuit optimized for a low-voltage DC (LVDC)...
