Skip to main content

previous disabled Page of 3
and
  1. No Access

    Article

    Effect of Modes of Deformation by Cold Rolling on Microstructure, Texture and Mechanical Properties of Ni-16Cr and Ni-16Mo Alloys

    The effect of modes of deformation (unidirectional, two-step and multi-step-cross rolling) by cold rolling on microstructure, texture, and mechanical properties of the Ni-16Cr and Ni-16Mo alloys has been discu...

    Kumud Kant Mehta, R. K. Mandal, A. K. Singh in Journal of Materials Engineering and Perfo… (2023)

  2. Chapter

    Correction to: Extent of Participation of Farm Women in Decision Making Regarding Agricultural Activities

    Anuradha Ranjan Kumari, Barun, S. K. Mandal in Women Farmers: Unheard Being Heard (2023)

  3. No Access

    Chapter

    Extent of Participation of Farm Women in Decision Making Regarding Agricultural Activities

    Women’s participation in the decision-making process has a significant impact on their improved status and greater role in the society. Their participation is potentially important to bring equality between wo...

    Anuradha Ranjan Kumari, Barun, S. K. Mandal in Women Farmers: Unheard Being Heard (2023)

  4. No Access

    Chapter and Conference Paper

    Cascaded Fuzzy and Three-Degree-of-Freedom Controller for Hybrid AGC Considering AC/DC Link

    This article examines how electric vehicles (EV) and renewable energy resources can be amalgamated into the proposed power network for Automatic Generation Control (AGC) under deregulation. Both areas contain ...

    Ashiwani Kumar, Ravi Shankar, R. K. Mandal in Recent Developments in Electrical and Elec… (2023)

  5. No Access

    Article

    Homogeneous and polymorphic transformations to ordered intermetallics in nanostructured Au–Cu multilayer thin films

    Atomic arrangements in the nanostructured grains and interfaces of thermally evaporated Au/Cu multilayer thin films on polycrystalline Si substrate have been explored through GIXRD, HRTEM, simulation, and dire...

    Ankit Singh, Maurya Sandeep Pradeepkumar in Journal of Materials Science (2021)

  6. No Access

    Article

    Microstructure and Mechanical Properties of the AA7075T7352 Aluminum Alloy

    Microstructure evolution and their effects on mechanical behaviors of the AA7075T7352 aluminum alloy are reported. Phase analysis was done by X-ray diffraction and transmission electron microscope. The presenc...

    Roopchand Tandon, K. K. Mehta, R. Manna in Transactions of the Indian Institute of Me… (2021)

  7. No Access

    Article

    Ferromagnetic Bismuth-Substituted CeO2 Nanostructures and Prevalence of Antiferromagnetic Clusters

    Bismuth-substituted CeO2 (Bi0.05Ce0.95O2) nanostructured material have displayed room temperature ferromagnetic behavior. The substitution of Ce ions with Bi3+ ions decreased the saturation magnetization (MS) val...

    S. K. Alla, Sher Singh Meena, Nidhi Gupta in Journal of Superconductivity and Novel Mag… (2020)

  8. No Access

    Chapter and Conference Paper

    Effect of Directional Grain Structure on Microstructure, Mechanical and Ballistic Properties of an AA-7017 Aluminium Alloy Plate

    The present work illustrates the correlation of microstructure along three directions namely, longitudinal (L), long-transverse (LT) and short-transverse (ST) on mechanical and ballistic properties of an AA-70...

    Pradipta Kumar Jena, K. Siva Kumar in Advances in Lightweight Materials and Stru… (2020)

  9. No Access

    Article

    Eriochrome Black T sensing using silver nanoparticle-reduced graphene oxide composite via luminescent “turn-off” mechanism and its biosorption on guava (Psidium guajava) leaf powder

    We report label-free sensitive and selective detection of Eriochrome Black T (EBT) in water using luminescent “turn-off” mechanism of silver nanoparticle-reduced graphene oxide composite. Silver nanoparticle-r...

    Prajwal Chettri, Manish K. Singh, Ajay Tripathi, Anand P. Pathak in Graphene Technology (2019)

  10. No Access

    Article

    Effects of Mode of Deformation and Extent of Reduction on Evolution of {111}-Fiber During Cold Rolling of Ni-16Cr Alloy

    The high ratio of relative resolved shear stress on a twin to planar slip system results in microstructural latent hardening (some kind of overshooting) by the twin system on the primary slip planes, which lea...

    K. K. Mehta, R. K. Mandal, A. K. Singh in Metallurgical and Materials Transactions A (2018)

  11. No Access

    Article

    Investigation of magnetic properties for Hf4+ substituted CeO2 nanoparticles for spintronic applications

    The single phase HfxCe1−xO2 (x = 0.01, 0.05 and 0.1) nanoparticles were produced via microwave refluxing technique. The substitution of Hf-ions into CeO2 lattice has been demonstrated by X-ray diffraction and tra...

    S. K. Alla, P. Kollu, Sher Singh Meena in Journal of Materials Science: Materials in… (2018)

  12. No Access

    Article

    Kinetics of p-Nitrophenol Reduction Catalyzed by PVP Stabilized Copper Nanoparticles

    Copper nanoparticles (CuNPs) in aqueous medium were prepared with alkaline hydrazine hydrate as the reductant and PVP as the stabilizing agent without any inert gas protection. Careful variation in the amount ...

    A. D. Verma, R. K. Mandal, I. Sinha in Catalysis Letters (2015)

  13. No Access

    Article

    Microstructure, Texture, and Orientation-Dependent Flow Behavior of Binary Ni-16Cr and Ni-16Mo Solid Solution Alloys

    This work describes microstructure, texture, and orientation-dependent flow behavior of Ni-16Cr and Ni-16Mo alloys in hot rolled and annealed condition. The high and low stacking fault energy values associated...

    K. K. Mehta, Prantik Mukhopadhyay in Metallurgical and Materials Transactions A (2015)

  14. No Access

    Article

    Stabilization of Nanocrystalline Silver by Sella and Mansoori Rice Starch

    The silver nanoparticles (AgNPs) have been synthesized by utilizing starch got from rice to serve as stabilizer and reducing agent in presence of sodium hydroxide. Two varieties of rice viz. Mansoori and Sella gr...

    Manish Kumar Singh, Manjri Singh in Transactions of the Indian Institute of Me… (2015)

  15. No Access

    Article

    Influence of Ga Substitution on the Nature of Glasses in Zr69.5Al7.5-xGaxCu12Ni11 and Ce75Al25-xGax Metallic Glass Compositions

    In this presentation, results of our recent investigations on the role of Ga on Al site in Zr69.5Al7.5-xGaxCu12Ni11 and Ce75Al25-xGax metallic glass compositions will be discussed. Ga like Al is normally expected...

    R.K. Mandal, R.S. Tiwari, Devinder Singh in MRS Online Proceedings Library (2014)

  16. No Access

    Article

    Mechanical Properties Anisotropy of Cold-Rolled and Solution-Annealed Ni-Based Hastelloy C-276 Alloy

    This work describes a correlation among texture, in-plane anisotropy in tensile properties, and yield locus in Ni-based Hastelloy C-276 alloy. The alloy exhibits moderate values of in-plane anisotropy and anis...

    K. K. Mehta, Prantik Mukhopadhyay in Metallurgical and Materials Transactions A (2014)

  17. Article

    Synthesis and Indentation Behavior of Amorphous and Nanocrystalline Phases in Rapidly Quenched Cu–Ga–Mg–Ti and Cu–Al–Mg–Ti Alloys

    Rapidly solidified ribbons of Cu–Ga–Mg–Ti and Cu–Al–Mg–Ti alloys show the formation of γ-brass type phase, which is an approximant of quasicrystals. The Cu–Ga–Mg–Ti alloy displays ordered γ-brass structure, w...

    Devinder Singh, Dharmendra Singh in Metallography, Microstructure, and Analysis (2013)

  18. No Access

    Article

    Phase Transformation Textures in Hot-Rolled Binary Ti-Nb Alloys

    The present work describes the phase transformation textures of three alloys, namely Ti-8Nb, Ti-12Nb, and Ti-16Nb after β and α + β solution treatments with different cooling rates. The strong, moderate, and weak...

    S. Banumathy, R. K. Mandal, A. K. Singh in Metallurgical and Materials Transactions A (2013)

  19. No Access

    Article

    Effect of thermomechanical processing on evolution of various phases in Ti-Nb alloys

    This paper deals with the effect of thermomechanical processing on microstructural evolution of three alloys, viz. Ti-8Nb, Ti-12Nb and Ti-16Nb. The alloys were hot rolled at 800°C and then subjected to various...

    S. Banumathy, K. S. Prasad, R. K. Mandal, A. K. Singh in Bulletin of Materials Science (2011)

  20. No Access

    Article

    Correlating SAXS analysis with LSPR behavior: poly(vinyl alcohol)-stabilized Ag nanoparticles

    We explore the localized surface plasmon resonance (LSPR) behavior of aqueous sols of PVA-stabilized AgNPs synthesized in presence of glucose as a reducing agent. The in situ synthesis parameters are tuned by ...

    Manjeet Singh, I. Sinha, A. K. Singh, R. K. Mandal in Journal of Nanoparticle Research (2011)

previous disabled Page of 3