Skip to main content

previous disabled Page of 5
and
  1. Article

    Open Access

    Measurement of absolute branching fractions of \( {\textrm{D}}_{\textrm{s}}^{+} \) hadronic decays

    Using e+e collision data collected at the BESIII detector at center-of-mass energies between 4.128 and 4.226 GeV, corresponding to an integrated luminosity of 7.33 fb1, we determine the absolute branching fract...

    M. Ablikim, M. N. Achasov, P. Adlarson, O. Afedulidis in Journal of High Energy Physics (2024)

  2. Article

    Open Access

    Search for ∆S = 2 nonleptonic hyperon decays Ω Σ0π and Ω nK

    Using (27.12 ± 0.14) × 108 ψ(3686) events collected by the BESIII detector at the center-of-mass energy of ...

    M. Ablikim, M. N. Achasov, P. Adlarson, O. Afedulidis in Journal of High Energy Physics (2024)

  3. Article

    Open Access

    Measurement of Born cross section of \( {e}^{+}{e}^{-}\to {\Sigma}^{+}{\overline{\Sigma}}^{-} \) at center-of-mass energies between 3.510 and 4.951 GeV

    Using 24.1 fb1 of e+e collision data collected with the BESIII detector at the BEPCII collider, the Born cross sections and effective form factors of the ...

    M. Ablikim, M. N. Achasov, P. Adlarson, O. Afedulidis in Journal of High Energy Physics (2024)

  4. Article

    Open Access

    Similar experimental study on retaining waterproof coal pillar in composite strata mining

    Numerous field examples of coal seam mining show that when coal seams under confined water are mined close to faults, water inrush effects on complex mining surfaces occur. Obeying similarity rules, physical s...

    Y. Q. Wang, X. Wang, J. S. Zhang, B. S. Yang, W. J. Zhu, Z. P. Wang in Scientific Reports (2022)

  5. No Access

    Article

    Effects of UV-B Irradiation Alone and in Combination with Salicylic Acid on the Growth and Active Ingredients of Dendrobium officinale

    The quality of Dendrobium officinale Kimura et Migo in cultivation was worse than those collected in wild, this work was conducted to explore a method that can improve the quality of D. officinale in cultivation.

    X. Y. Feng, D. D. Cui, L. J. Zeng, Z. X. Wu in Russian Journal of Plant Physiology (2021)

  6. No Access

    Article

    Particle Dissolution and Recrystallization Progress of Al–Mg–Si–Cu Alloy during Solution Treatment

    Particle dissolution and recrystallization progress of Al–Mg–Si–Cu alloy during solution treatment at 555°C was studied by microstructure, hardness and electrical conductivity characterization, and analytical ...

    X. F. Wang, M. X. Guo, H. B. Wang, W. F. Peng in Physics of Metals and Metallography (2020)

  7. No Access

    Article

    Bovine bta-microRNA-1271 Promotes Preadipocyte Differentiation by Targeting Activation Transcription Factor 3

    Yanbian yellow cattle are one of the top five largest breeds of cattle in China. We had previously found that bta-miR-1271 is differentially expressed in the longissimus dorsi muscles of Yanbian yellow bulls a...

    H. Y. Xu, J. Shao, B. Z. Yin, L. M. Zhang, J. C. Fang, J. S. Zhang in Biochemistry (Moscow) (2020)

  8. No Access

    Article

    Downregulation of Salmonella Virulence Gene Expression During Invasion of Epithelial Cells Treated with Lactococcus lactis subsp. cremoris JFR1 Requires OppA

    Invasion of Salmonella into host intestinal epithelial cells requires the expression of virulence genes. In this study, cell culture models of human intestinal cells (mucus-producing HT29-MTX cells, absorptive Ca...

    J. S. Zhang, M. Corredig, R. Morales-Rayas in Probiotics and Antimicrobial Proteins (2020)

  9. No Access

    Chapter and Conference Paper

    Experimental Study of Nonlinear Long Wave Propogation Over a Fine Gravel Bed

    A series of laboratory experiments have been carried out to investigate nonlinear long wave propagation over a fine gravel bed, in which water surface elevation, shear flow inside the bottom boundary layer and...

    L. L. Tong, J. H. Zheng, J. S. Zhang, F. S. Qian in APAC 2019 (2020)

  10. No Access

    Chapter and Conference Paper

    Numerical Analysis of Storm Surge on the Radial Sand Ridges During “Muifa” Typhoon

    The radial sand ridges (hereafter indicated as “RSRs”) in the South Yellow Sea are famous for its complex bathymetry and tidal wave systems. As marine development increasingly expanding, the characteristics of...

    N. R. Wang, J. S. Zhang, K. F. Chen, W. S. Zhang, P. D. Lu, L. L. Yu in APAC 2019 (2020)

  11. No Access

    Article

    Effect of Main Elements (Zn, Mg, and Cu) on Hot Tearing Susceptibility During Direct-Chill Casting of 7xxx Aluminum Alloys

    New 7xxx aluminum alloys with high alloying contents are being designed, which could induce serious hot tearing defects during direct-chill (DC) casting. Among all factors affecting hot tearing of 7xxx alloys,...

    Y. Li, Z. R. Zhang, Z. Y. Zhao, H. X. Li in Metallurgical and Materials Transactions A (2019)

  12. No Access

    Article

    A new nonlinear dopant kinetic model of memristor and its application

    To improve the effectiveness of memristor model in complex network, the drift model of memristor is further optimized. In this paper, based on both the existing nonlinear do** kinetic model and sinusoidal fu...

    F Xu, J Q Zhang, S F Huang, J S Zhang, S Q **e, M S Wang in Indian Journal of Physics (2019)

  13. No Access

    Article

    Maximizing the hard magnetic properties of melt-spun Ce–La–Fe–B alloys

    To balance the utilization of rare earth (RE) resource and develop Ce-based permanent magnets with high performance/cost ratio, the role of La substitution in the melt-spun (Ce1−xLax)yFe14B (x = 0–0.4, and 0.5; y

    X. F. Liao, J. S. Zhang, H. Y. Yu, X. C. Zhong, L. Z. Zhao in Journal of Materials Science (2019)

  14. Article

    Open Access

    Understanding the element segregation and phase separation in the Ce-substituted Nd-(Fe,Co)-B based alloys

    Ce substituted Nd2Fe14B (2:14:1)-type permanent magnets have shown increasing potential in the applications due to their high properties/cost ratio. However, the element segregation and phase separation in the Ce...

    L. Z. Zhao, J. S. Zhang, G. Ahmed, X. F. Liao, Z. W. Liu in Scientific Reports (2018)

  15. No Access

    Article

    Experimental and Theoretical Studies of the Hot Tearing Behavior of Al-xZn-2Mg-2Cu Alloys

    The effect of Zn addition on the hot tearing susceptibilities of non-refined Al-xZn-2Mg-2Cu (x = 2-12 wt pct) alloys was investigated via direct crack observations and load response measurements. The obtained exp...

    Y. Li, X. Gao, Z. R. Zhang, W. L. **ao in Metallurgical and Materials Transactions A (2017)

  16. No Access

    Article

    Effect of Thermomechanical Processing on Microstructure, Texture Evolution, and Mechanical Properties of Al-Mg-Si-Cu Alloys with Different Zn Contents

    The effect of thermomechanical processing on microstructure, texture evolution, and mechanical properties of Al-Mg-Si-Cu alloys with different Zn contents was studied by mechanical properties, microstructure, ...

    X. F. Wang, M. X. Guo, Y. Chen, J. Zhu in Metallurgical and Materials Transactions A (2017)

  17. No Access

    Article

    Effect of Zn addition on the precipitation behaviors of Al–Mg–Si–Cu alloys for automotive applications

    Effect of Zn addition on the precipitation kinetics and age-hardening response of Al–Mg–Si–Cu alloys was investigated by differential scanning calorimetry (DSC), hardness measurements, tensile tests and micros...

    M. X. Guo, X. K. Zhang, J. S. Zhang, L. Z. Zhuang in Journal of Materials Science (2017)

  18. No Access

    Article

    Synthesis and Characterization of In Situ Dendritic/Particulate α-Al(Fe,TM)Si Phase Reinforced Al Matrix Composites

    The strength and ductility of transition metallic element alloyed Al alloys could be inevitably and severely weakened if these elements appeared as coarse intermetallics. Present studies aimed to optimize the ...

    L. G. Hou, Shuai Wang, Z. B. He, D. Zhang in Metallurgical and Materials Transactions A (2016)

  19. No Access

    Article

    Roles of Alloy Composition and Grain Refinement on Hot Tearing Susceptibility of 7××× Aluminum Alloys

    During the production of high-strength 7××× aluminum alloys, hot tearing has set up serious obstacles for attaining a sound billet/slab. In this research, some typical 7××× alloys were studied using constraine...

    Q. L. Bai, Y. Li, H. X. Li, Q. Du in Metallurgical and Materials Transactions A (2016)

  20. No Access

    Article

    The Influences of Grain Size and Morphology on the Hot Tearing Susceptibility, Contraction, and Load Behaviors of AA7050 Alloy Inoculated with Al-5Ti-1B Master Alloy

    The influences of grain size and morphology on the hot tearing susceptibility of AA7050 alloy inoculated with Al-5Ti-1B master alloy were investigated by the authors. It was found that with the optimal additio...

    Y. Li, Q. L. Bai, J. C. Liu, H. X. Li, Q. Du in Metallurgical and Materials Transactions A (2016)

previous disabled Page of 5