Abstract
Accumulation of heavy metals in plant parts due to environmental uptake may have repercussions on the plant's health and integrity. In this study, we quantified various heavy metals in natural rubber (NR) latex collected from Mantin, Negeri Sembilan, Malaysia (sub-urban area) and Batu Embun, Pahang, Malaysia (rural area) for 12 consecutive months. Acid digestion as sample pre-treatment was performed prior to detection and quantification of the heavy metals, namely Cr, Cu, Fe, Mn, Pb, and Zn, using inductively coupled plasma–optical emission spectrometer (ICP-OES). Then, plasticity test and preparation of polystyrene/natural rubber (PS/NR) blends were conducted to investigate the effects of heavy metals on the integrity of NR. It was found that the plasticity retention index (PRI) was inversely proportional to the concentration of heavy metals in NR. Conversely, high levels of heavy metals in latex had acted as an excellent compatibilizer in PS/NR blends with improved properties of tensile strength and impact energy. The most deposited heavy metals (4391.2 ppm) compatibilized PS/NR blends with the highest tensile strength of 27.4 MPa and impact energy of 17.55 kJ/m2. In contrast, the least accumulated heavy metals (18.8 ppm) resulted in PS/NR blends with the lowest tensile strength (2.61 MPa) and impact energy (2.70 kJ/m2). The phase distribution of PS/NR was observed to be more uniformed when high levels of heavy metals were available in the blends. Our discovery has indirectly demonstrated the role of NR in eliminating heavy metals from the environment which in turn, acting as a good compatibilizer in the blending of PS/NR.
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig1_HTML.png)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig2_HTML.png)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig3_HTML.png)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig4a_HTML.png)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig4b_HTML.png)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig5_HTML.jpg)
![](http://media.springernature.com/m312/springer-static/image/art%3A10.1007%2Fs42464-023-00199-2/MediaObjects/42464_2023_199_Fig6_HTML.png)
Similar content being viewed by others
Data availability
The authors declare that the data supporting the findings of this study are available within the paper. Should any raw data files be needed in another format they are available from the corresponding author upon reasonable request.
References
Kumar M, Gupta N, Ratn A, Awasthi Y, Prasad R, Trivedi A et al (2020) Biomonitoring of heavy metals in river ganga water, sediments, plant, and fishes of different trophic levels. Biol Trace Elem Res 193:536–547
Sevik H, Ozel HB, Cetin M, Özel HU, Erdem T (2019) Determination of changes in heavy metal accumulation depending on plant species, plant organism, and traffic density in some landscape plants. Air Qual Atmos Heal 12:189–195
Ghori NH, Ghori T, Hayat MQ, Imadi SR, Gul A, Altay V et al (2019) Heavy metal stress and responses in plants. Int J Environ Sci Technol 16:1807–1828
Rani V, Vats A, Bharadwaj ACB, Kandpal S (2020) Heavy metal toxicity, mechanism, and regulation. cellular and molecular phytotoxicity of heavy metals. Springer, Cham, pp 43–56
WHO. (1996) Trace elements in human nutrition and health World Health Organization. World Health Organization, Geneva 1–360.
An Z, Zhao Y, Zhang X, Huang X, Hu Y, Cheng H, Huang H (2019) A high-density genetic map and QTL map** on growth and latex yield-related traits in Hevea brasiliensis Müll. Arg Ind Crops Prod 132:440–448
Bottier C (2020) Biochemical composition of Hevea brasiliensis latex: a focus on the protein, lipid, carbohydrate and mineral contents. Advances in botanical research. Academic Press Inc., Cambridge, pp 201–237
Yusof MJM, Tahir NAM, Firdaus F, Yusoff SFM (2018) Diimide reduction of liquid natural rubber in hydrazine hydrate/hydrogen peroxide system: a side reaction study. Malaysian J Anal Sci 22:1023–1030
Bellacicco S, Prades A, Char C, Vaysse L, Granet F, Lacote R et al (2018) The sugar and polyol composition of Hevea brasiliensis latex depends on the clonal origin of the tree. J Rubber Res 21:224–235
Liengprayoon S, Vaysse L, Jantarasunthorn S, Wadeesirisak K, Chaiyut J, Srisomboon S, Bottier C (2021) Distribution of the non-isoprene components in the four Hevea brasiliensis latex centrifugation fractions. J Rubber Res 24:759–769
Salomez M, Subileau M, Intapun J, Bonfils F, Sainte-Beuve J, Vaysse L, Dubreucq E (2014) Micro-organisms in latex and natural rubber coagula of Hevea brasiliensis and their impact on rubber composition, structure and properties. J Appl Microbiol 117:921–929
Resing WL. (1955) Variability of Hevea latex. Foundation for Rubber Research and Development. Archs Rubb Cult 32:751
Jawjit W, Pavasant P, Kroeze C (2015) Evaluating environmental performance of concentrated latex production in Thailand. J Clean Prod 98:84–91
Silva LG (1997) Changes in protein profile during coagulation of latex from Carica papaya. raz. J Med Biol Res 30:615–619
Chen SF (1979) Composition of hevea latex [in Malaysia].[Lecture notes]. In Latex and Rubber Analysis. Kuala Lumpur (Malaysia). 21 May-23 Jun 1979.
Takayama M, Morita K (2004) Finite element analysis of natural rubber isolator. In: JSSI 10th Anniversary Symposium on Performance Response Controlled Building spp. 73–9.
Tahir H, Misran M, Othman MR, Ibrahim N (2018) Metal selectivity of Hevea protein isolated from natural rubber latex skim serum. Int J Eng Technol 7:426–429
Gan SN, Ting KF (1993) Effect of treating latex with some metal ions on storage hardening of natural rubber. Polymer 34:2142–2147
Hayeemasae N, Salleh SZ, Ismail H (2019) Utilization of chloroprene rubber waste as blending component with natural rubber: aspect on metal oxide contents. J Mater Cycles Waste Manag 21:1095–1105
Asaletha R, Kumaran MG, Thomas S (1999) Thermoplastic elastomers from blends of polystyrene and natural rubber: morphology and mechanical properties. Eur Polym J 35:253–271
Ishak I, Rosli FD, Mohamed J, Ismail MFM (2015) Comparison of digestion methods for the determination of trace elements and heavy metals in human hair and nails. Malaysian J Med Sci MJMS 22:11
Sulaiman FR, Hamzah HA (2018) Heavy metals accumulation in suburban roadside plants of a tropical area (Jengka, Malaysia). Ecol Process 7:1–11
Ahmad A (2017) Rubber properties of selected clones. Int Proc IRC 20171(1):599–609
Aguele FO, Idiaghe JA, Apugo-nwosu TU (2015) A study of quality improvement of natural rubber products by drying methods. J Mater Sci Chem Eng 11:7–12
Ong EL (2000) Characterization of new latex-timber clones of natural rubber. J Appl Polym Sci 78:1517–1520
Edison R (2007) Trial of zeolite application for water purification utilized in crumb rubber processing. J Zeolit Indones 6:1–9
Moraes VH de F, Moraes LAC, Moreira A, Souza NP de, Yokoyama R, Pereira AV, et al. (2013) Performance of rubber tree crown and panel clones in the southwest of the state of Mato Grosso, Brazil. Pesqui Agropecuária Bras 48:597–604
Taweepreda W (2013) Rubber recovery from centrifuged natural rubber latex residue using sulfuric acid. Songklanakarin J Sci Technol 35:213–216
Goehring L, Clegg WJ, Routh AF (2013) Plasticity and fracture in drying colloidal films. Phys Rev Lett 110:1–5
Berto P, Grelier S, Peruch F (2018) Controlled degradation of polyisoprene and polybutadiene: a comparative study of two methods. Polym Degrad Stab 154:295–303
Panapitiya N, Wijenayake S, Nguyen D, Karunaweera C, Huang Y, Balkus K et al (2016) Compatibilized immiscible polymer blends for gas separations. Materials (Basel) 9:643
Belfiore LA, Indra EM (2000) Transition metal compatibilization of poly (vinylamine) and poly (ethylene imine). J PolymSci B Polym Phys 38:552–561
Blanco I, Abate L, Bottino FA, Bottino P (2014) Thermal behaviour of a series of novel aliphatic bridged polyhedral oligomeric silsesquioxanes (POSSs)/polystyrene (PS) nanocomposites: the influence of the bridge length on the resistance to thermal degradation. Polym Degrad Stab 102:132–137
Sresungsuwan N, Hansupalak N (2013) Prediction of mechanical properties of compatibilized styrene/natural-rubber blend by using reaction conditions: central composite design vs. artificial neural networks. J Appl Polym Sci 127:356–365
Yusof MJM, Abdullah I, Yusoff SF (2017) Sintesis dan pencirian getah asli cecair terhidrogen untuk adunan polimer. Sains Malays 46:1817–1823
Huang J, Fan J, Yin S, Chen Y (2019) Design of remotely, locally triggered shape-memory materials based on bicontinuous polylactide/epoxidized natural rubber thermoplastic vulcanizates via regulating the distribution of ferroferric oxide. Compos Sci Technol 182:107732
BoonsongK SM, Lopattananon N (2008) Compatibilization of natural rubber (NR) and chlorosulfonated polyethylene (CSM) blends with zinc salts of sulfonated natural rubber. Warasan Songkhla Nakharin 30:49–499
Zheng H, Zhang Y, Peng Z, Zhang Y (2004) Influence of the clay modification and compatibilizer on the structure and mechanical properties of ethylene-propylene-diene rubber/montmorillonite composites. J Appl Polym Sci 92:638–646
Jain R, Tracy JE, Ghosh K (1993) High performance curable PPO/monomeric epoxy compositions with tin metal salt compatibilizing agent. U.S. Patent No. 5,262,491. Washington, DC: U.S. Patent and Trademark Office
Panapitiya NP, Wijenayake SN, Huang Y, Bushdiecker D, Nguyen D, Ratanawanate C et al (2014) Stabilization of immiscible polymer blends using structure directing metal organic frameworks (MOFs). Polymer 55:2028–2034
Li F, Anderson S. (2003) Using direct solid sampling ICP‐MS to complement SEM‐EDX and SIMS in characterizing semiconductor materials. In: AIP Conference Proceedings. American Institute of Physicspp 715–9.
Alomary A, Belhadj S, Obeidat SM (2012) A comparison of SEM-EDS with ICP-OES for the quantitative elemental determination of Algerian mediterranean sea sediments. Jordan J Chem 146:1–9
Acknowledgements
This work was supported by the Ministry of Higher Education (grant FRGS/1/2016/STG01/UKM/02/4) and the National University of Malaysia (GUP-2017-004).
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
There are no conflicts of interest to declare.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Yusof, M.J.M., Latif, M.T. & Yusoff, S.F.M. The ambivalent effects of heavy metals present in natural rubber latex. J Rubber Res 26, 111–123 (2023). https://doi.org/10.1007/s42464-023-00199-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s42464-023-00199-2