-
Article
Comparison the Effect of MQL, Wet and Dry Turning on Surface Topography, Cylindricity Tolerance and Sustainability
The increasing needs for the production of high quality parts require the use of new techniques to produce parts with higher precision. One of these modern techniques is minimum quantity lubricant (MQL) machin...
-
Article
Experimental investigation of the effect of EDM parameters and dielectric type on the surface integrity and topography
The electrical discharge machining (EDM) process is mostly used in conditions that complex and intricate shapes need to be machined on very hard metals. However, the process leaves behind some undesirable prop...
-
Article
Erratum to: The Effect of Quench-Induced Residual Stresses on the Distortion of Machined Thin-Walled Parts
-
Article
The Effect of Quench-Induced Residual Stresses on the Distortion of Machined Thin-Walled Parts
In the heat treatment process, during the quenching of aluminum alloy, a high level of residual stresses is observed due to the severe thermal gradient at the surface and center of the work piece, which acts a...
-
Article
Effect of machining-induced residual stress on the distortion of thin-walled parts
One of the main problems in the machining of thin-walled parts made of high-strength aluminum alloys is distortion and dimensional instability after machining, which leads to an increase in scraped parts and t...
