-
Article
Influence of hot rolling + heat treatment on microstructure and mechanical properties of NM500/Q345/NM500 composite plate
The NM500/Q345/NM500 composite plates were subjected to different hot rolling and heat treatment processes in this paper. The influence of hot rolling and heat treatment on the microstructure, element distribu...
-
Article
Effect of Reduction on Bonding Interface of Hot-rolled Wear-resistant Steel BTW1/Q345R Cladding Plate
Wear-resistant cladding plates consisting of a substrate (Q345R) and a clad layer (BTW1) were bonded through hot rolling at the temperature of 1 200 °C and a rolling speed of 0.5 m/s. The microhardness of the ...
-
Article
Hot Deformation Behavior and Microstructural Evolution of Antibacterial Austenitic Stainless Steel Containing 3.60% Cu
Hot deformation behavior of as-cast antibacterial austenitic stainless steel containing 3.60% copper was investigated in a temperature range of 900-1150 °C and strain rate range of 0.01-20 s−1. At strain rates hi...
-
Chapter
Physical Simulation of Critical Blowing Rate of Slag Entrapment of 80 Tons Ladle
The slag entrapment under different conditions of 80t blowing argon ladle furnace was investigated by physical simulation. The water was used to simulate liquid steel and liquid paraffin was for slag. The proc...
-
Article
A Comparison of Texture Development in an Experimental and Industrial Tertiary Oxide Scale in a Hot Strip Mill
Electron backscatter diffraction (EBSD) has been used to investigate the microstructure and texture-based features of an industrial tertiary oxide scale formed on a micro-alloyed low-carbon steel from a hot st...