Abstract
A series of experiments were performed to determine rock mechanical parameters related to hydraulic fracturing of coal. The effect of confining pressure and pore pressure on the strength of coal was studied. Experimental results show that the coal seam in the study areas has a relatively low elastic modulus, high Poisson’s ratio, high fragility and is easily broken and compressed. The coal seam is considered as a transversely isotropic medium, since the physical properties in the direction of bedding plane and orthogonal to the bedding plane vary markedly. Based on the generalized plane strain model, stress distribution for an arbitrarily orientated wellbore in the coal seam was determined. In a horizontal well, hydraulic fracturing was found to initiate in the coal seam mass due to tensile failure, or from cleats due to shear or tensile failure. For those coal seams with abundant natural cleats, hydraulic fracture initiation can be induced by any of these mechanisms. In this study, hydraulic fracture initiation criteria for a horizontal well in a coal seam were established.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Aadnoy B S. Continuum Mechanics Analysis of the Stability of Inclined Boreholes in Anisotropic Rock Formations. Ph.D. Dissertation. The University of Trondheim. 1987
Aadnoy B S. Stresses around horizontal boreholes drilled in sedimentary rocks. Journal of Petroleum Science and Engineering. 1989. 2(4): 349–360
Akulich A V. Numerical simulation of hydraulic fracture crack propagation. Moscow University Mechanics Bulletin. 2008. 63(1): 6–12
Amadei B. Rock Anisotropy and the Theory of Stress Measurements (Lecture Notes in Engineering). Germany: Springer-Verlag. Berlin Heidelberg New York Tokyo. 1983. 45–70
Amadei B. In situ stress measurements in anisotropic rock. International Journal of Rock Mechanics and Mining Science & Geomechanics Abstracts. 1984. 21(6): 327–338
Amadei B. Importance of anisotropy when estimating and measuring in situ stresses in rock. International Journal of Rock Mechanics and Mining Science & Geomechanics Abstracts. 1996. 33(3): 293–325
Bruno M S and Nakagawa F M. Pore pressure influence on tensile fracture propagation in sedimentary rock. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts. 1991. 28(4): 261–273
Chen M, Jiang H, Zhang G Q, et al. The experimental investigation of fracture propagation behavior and fracture geometry in hydraulic fracturing through oriented perforations. Petroleum Science and Technology. 2010. 28(13): 1297–1306
Du Q H, Yu S T and Yao Z H. Theory of Elasticity. Science Press. Bei**g. 1986 (in Chinese)
Hossain M M, Rahman M K and Rahman S S. A comprehensive monograph for hydraulic fracture initiation from deviated wellbores under arbitrary stress regimes. Asia Pacific Oil and Gas Conference and Exhibition, 20–22 April 1999, Jakarta, Indonesia (SPE 54360)
Jeffrey R G, Zhang X and Thiercelin M. Hydraulic fracture offsetting in naturally fractured reservoirs: Quantifying a long-recognized process. SPE Hydraulic Fracturing Technology Conference, 19–21 January 2009, The Woodlands, Texas (SPE 119351)
** Y, Qi Z L, Chen M, et al. Time-sensitivity of the Kaiser effect of acoustic emission in limestone and its application to measurements of in-situ stress. Petroleum Science. 2009. 6(2): 176–180
** Y, Yuan J B, Chen M, et al. Determination of rock fracture toughness K‖C and its relationship with tensile strength. Rock Mechanics and Rock Engineering. 2011. 44: 621–627
Lekhnitskii S G. Theory of Elasticity of an Anisotropic Body. Moscow: Mir Publishers. 1981
Li T L. Preliminary research on development of cracks in coal seams by hydraulic fracture. Earth Science—Journal of China University of Geosciences. 1994. 19(4): 537–545 (in Chinese)
Li T L. Analysis of coalbed hydraulic fracturing mechanism. Natural Gas Industry. 1997. 17(4): 53–56 (in Chinese)
Li Z G, Fu S L, Wu X M, et al. Research on mechanical property tests and mechanism of hydraulic fracture of gas well in coal beds. Petroleum Drilling Techniques. 2000. 28(3): 10–13 (in Chinese)
Liu B C and Lu H S. Elastic Mechanics. Metallurgical Industry Press. Bei**g. 1979 (in Chinese)
Nordgren R. Propagation of a vertical hydraulic fracture. SPE Journal. 1972. 12(4): 306–314
Olson J E. Multi-fracture propagation modeling: Applications to hydraulic fracturing in shales and tight gas sands. The 42nd US Rock Mechanics Symposium (USRMS), 29 June–2 July 2008, San Francisco, CA
Ong S H. Borehole Stability. Ph.D. Dissertation. University of Oklahoma. 1994. Norman, Oklahoma
Rice J R. Mathematical analysis in the mechanics of fracture. In: Fracture: An Advanced Treatise (Edited by Liebowitz H). Academic Press, New York. 1968. 191–311
Thiercelin M. Hydraulic fracture propagation in discontinuous media. International Conference on Rock Joints and Jointed Rock Masses, 7–8 January 2009, Tucson, Arizona
Thomson S. The role of directional drilling for safety in coal mining. Proceedings of the 11th Turkish Coal Congress, 10–12 June 1998, Bartin-Amasra, Turkey
Valkó P and Economides M J. Propagation of hydraulically induced fractures: A continuum damage mechanics approach. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts. 1994. 31(3): 221–229
Whittaker B N, Singh R N and Sun G. Rock Fracture Mechanics—Principles Design and Applications. Amsterdam: Elsevier, New York. 1992
Zhang G Q. Rock failure with weak planes by self-locking concept. International Journal of Rock Mechanics and Mining Sciences. 2009. 46(6): 974–982
Zhang G Q and Chen M. Study of the optimal timing for refracturing. Petroleum Science and Technology. 2009. 27(10): 969–983
Zhang G Q and Chen M. Dynamic fracture propagation in hydraulic re-fracturing. Journal of Petroleum Science and Engineering. 2010a. 70(3–4): 266–272
Zhang G Q and Chen M. Study of damage mechanism by production testing after acid fracturing of carbonate reservoir. Petroleum Science and Technology. 2010b. 28(2): 125–134
Zhang G Q and Chen M. The relationship between the production rate and initiation location of new fractures in a refractured well. Petroleum Science and Technology. 2010c. 28(7): 655–666
Zhao Z F and Chen M. Relationship between rock fracture toughness and physical properties. Petroleum Science. 2006. 3(1): 56–60
Zhou J, Chen M, ** Y, et al. Analysis of fracture propagation behavior and fracture geometry using a tri-axial fracturing system in naturally fractured reservoirs. International Journal of Rock Mechanics and Mining Sciences. 2008. 45(7): 1143–1152
Zhou J, Chen M, ** Y, et al. Experimental investigation of hydraulic fracturing in random naturally fractured blocks. International Journal of Rock Mechanics and Mining Sciences. 2010. 47(7): 1193–1199
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hou, B., Chen, M., Wang, Z. et al. Hydraulic fracture initiation theory for a horizontal well in a coal seam. Pet. Sci. 10, 219–225 (2013). https://doi.org/10.1007/s12182-013-0270-9
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12182-013-0270-9