Log in

Influence of organic waste and residue mud additions on chemical, physical and microbial properties of bauxite residue sand

  • Research Article
  • Published:
Environmental Science and Pollution Research Aims and scope Submit manuscript

Abstract

Background, aim and scope

In an alumina refinery, bauxite ore is treated with sodium hydroxide at high temperatures and pressures and for every tonne of alumina produced, about 2 tonnes of alkaline, saline bauxite processing waste is also produced. At Alcoa, a dry stacking system of disposal is used, and it is the sand fraction of the processing waste that is rehabilitated. There is little information available regarding the most appropriate amendments to add to the processing sand to aid in revegetation. The purpose of this study was to investigate how the addition of organic wastes (biosolids and poultry manure), in the presence or absence of added residue mud, would affect the properties of the residue sand and its suitability for revegetation.

Materials and methods

Samples of freshly deposited residue sand were collected from Alcoa's Kwinana refinery. Samples were treated with phosphogypsum (2% v/v), incubated, and leached. A laboratory experiment was then set up in which the two organic wastes were applied at 0 or the equivalent to 60 tonnes ha−1 in combination with residue mud added at rates of 0%, 10% and 20% v/v. Samples were incubated for 8 weeks, after which, key chemical, physical and microbial properties of the residue sand were measured along with seed germination.

Results and discussion

Additions of residue mud increased exchangeable Na+, ESP and the pH, and HCO 3 and Na+ concentrations in saturation paste extracts. Additions of biosolids and poultry manure increased concentrations of extractable P, NH +4 , K, Mg, Cu, Zn, Mn and Fe. Addition of residue mud, in combination with organic wastes, caused a marked decrease in macroporosity and a concomitant increase in mesoporosity, available water holding capacity and the quantity of water held at field capacity. With increasing residue mud additions, the percentage of sample present as sand particles (<1 mm diameter) decreased, and the percentage present in aggregated form (>2 mm diameter) increased; greatest aggregation occurred where a combination of residue mud and poultry manure were added. Stability of aggregates, as measured by wet sieving, was greatest where poultry manure was applied. Although total organic C and soluble organic C were greater in biosolids than poultry manure treatments, the reverse was the case for microbial biomass C and basal respiration. In the biosolids and poultry manure treatments, increasing residue mud additions tended to increase soluble C, microbial biomass C and basal respiration. Germination index of watercress was highest in control samples and reduced by additions of biosolids and poultry manure which was attributed to the high EC and possibly high extractable P and NH +4 .

Conclusions

The concurrent addition of residue mud and organic wastes can improve chemical, microbial and particularly physical properties of residue sand. Future research should include neutralisation of the mud (e.g. with gypsum) and subsequent leaching to remove salts originating from both the mud and organic wastes.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Subscribe and save

Springer+ Basic
EUR 32.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or Ebook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4

Similar content being viewed by others

References

  • Aitken RL, Scott BJ (1999) Magnesium. In: Peverill KI, Sparrow LA, Reuter DJ (eds) Soil analysis, an interpretation manual. CSIRO Publishing, Victoria, pp 255–262

    Google Scholar 

  • Amezketa E (1999) Soil aggregate stability: a review. J Sustain Agric 14:83–151

    Article  Google Scholar 

  • Anderson JPE (1982) Soil respiration. In: Page AL (ed) Methods of soil analysis, part 2. Chemical and microbiological properties. American Society of Agronomy, Madison, pp 837–871

    Google Scholar 

  • Blake GR, Hartge KH (1986) Particle density. In: Klute A (ed) Methods of soil analysis, part 1. Physical and mineralogical methods, 2nd edn. American Society of Agronomy, Madison, pp 377–382

    Google Scholar 

  • Chen CR, Phillips IR, Wei LL, Xu ZH (2009) Behaviour and dynanics of di-ammonium phosphate in bauxite processing sand in Western Australia—II. Phosphorus fractions and availability. Environ Sci Pollut Res;17:1110–1118

    Google Scholar 

  • Colwell JD (1963) The estimation of the phosphorus fertilizer requirements of wheat in southern New South Wales by soil analysis. Aust J Exp Agric Anim Husb 3:190–198

    Article  CAS  Google Scholar 

  • Cooling DJ (2007) Improving the sustainability of residue management practices – Alcoa World Alumina. In: Fourie AB, Jewell RJ (eds) Paste 2007 – Proceedings of the Tenth International Seminar on Paste and Thickened Tailings. Australian Centre for Geomechanics, Perth, pp 3–15

    Google Scholar 

  • Das SK, Yin W (2007) The worldwide aluminium economy: the current state of the industry. J Miner Met Mater Soc 59:57–63

    Google Scholar 

  • Edwards AP, Bremner JM (1967) Microaggregates in soils. J Soil Sci 18:64–73

    Article  CAS  Google Scholar 

  • Gourley CJP (1999) Potassium. In: Peverill KI, Sparrow LA, Reuter DJ (eds) Soil analysis, an interpretation manual. CSIRO Publishing, Victoria, pp 229–245

    Google Scholar 

  • Handreck KA (1997) Phosphorus requirements of Australian native plants. Aust J Soil Res 35:241–289

    Article  Google Scholar 

  • Handreck KA, Black ND (2002) Growing media for ornamental plants and turf. NSW University Press, Randwick

    Google Scholar 

  • Harris PJ (1994) Consequences of the spatial distribution of microbial communities in soil. In: Ritz K, Dighton J, Giller KE (eds) Beyond the biomass. Compositional and functional analysis of soil microbial communities. Wiley, Chichester, pp 239–246

    Google Scholar 

  • Haynes RJ (1986) Uptake and assimilation of mineral nitrogen by plants. In: Haynes RJ (ed) Mineral nitrogen in the p lant Soil System. Academic Press, Orlando, pp 303–378

    Google Scholar 

  • Haynes RJ (1993) Effect of sample pretreatment on aggregate stability measured by wet sieving or turbidimetry on soils of different crop** history. J Soil Sci 44:261–270

    Article  Google Scholar 

  • Haynes RJ (2005) Labile organic matter fractions as central components of the quality of agricultural soils: an overview. Adv Agron 85:221–268

    Article  CAS  Google Scholar 

  • Haynes RJ, Beare MH (1996) Aggregation and organic matter storage in meso-thermal, humid soils. In: Carter MR, Stewart BA (eds) Structure and Organic Matter Storage in Agricultural Soils. CRC Press, Boca Raton, pp 213–262

    Google Scholar 

  • Haynes RJ, Murtaza G, Naidu R (2009) Inorganic and organic constituents and contaminants of biosolids: implications for land application. Adv Agron 104:165–267

    Article  CAS  Google Scholar 

  • Jones BEH, Haynes RJ (2010) Bauxite processing residue: a critical review of its formation, properties, storage and revegetation. Crit Rev Env Sci Technol (in press)

  • Jones BEH, Haynes RJ, Phillips IR (2010) Effect of amendment of bauxite processing sand with organic materials on its chemical, physical and microbial properties. J Environ Manage (in press)

  • Kopittke PM, Menzies NW (2005) Effect of pH on Na induced Ca deficiency. Plant Soil 269:119–129

    Article  CAS  Google Scholar 

  • Kumar S, Kumar R, Bandopadhyay A (2006) Innovative methodologies for the utilisation of wastes from metallurgical and allied industries. Resour Conserv Recycl 48:301–314

    Article  Google Scholar 

  • Lindsay WL, Norvell WA (1978) Development of a DTPA soil test for zinc, iron, manganese and copper. Soil Sci Soc Am J 42:421–428

    Article  CAS  Google Scholar 

  • Moral R, Moreno-Caselles J, Purez-Murcia MD, Perez-Espinosa B, Rufete B, Paredes C (2005) Characterisation of the organic matter pool in manures. Bioresour Technol 96:153–158

    Article  CAS  Google Scholar 

  • Nannipieri P, Ascher J, Ceccherini MT, Landi L, Pietramellara G, Renella G (2003) Microbial interactions and soil functions. Eur J Soil Sci 54:655–670

    Article  Google Scholar 

  • Rayment GE, Higginson FR (1992) Australian laboratory handbook of soil and Water Chemical Methods. Inkata Press, Melbourne

    Google Scholar 

  • Rietz DN, Haynes RJ (2003) Effects of irrigation-induced salinity and sodicity on soil microbial activity. Soil Biol Biochem 35:845–854

    Article  CAS  Google Scholar 

  • Shaw RJ (1999) Soil salinity—electrical conductivity and chloride. In: Peverill KI, Sparrow LA, Reuter DJ (eds) Soil analysis: an interpretation manual. CSIRO Publishing, Victoria, pp 129–145

    Google Scholar 

  • Six J, Bossuyt H, Degryze S, Denef K (2004) A history of research on the link between (micro)aggregates, soil biota, and soil organic matter dynamics. Soil Tillage Res 79:7–31

    Article  Google Scholar 

  • Sumner ME (1993) Sodic soils: new perspectives. Aust J Soil Res 31:683–750

    Article  Google Scholar 

  • Tabatabai MA (1994) Soil enzymes. In: Weaver RW, Angle JS, Bottomley PS (eds) Methods of soil analysis, part 2. Microbiological and biochemical properties. Soil Science Society of America, Madison, pp 775–833

    Google Scholar 

  • Thiyagarajan T, Phillips IR, Dell B, Bell RW (2009) Micronurient fractionation and plant availability in bauxite-processing residue sand. Aust J Soil Res 47:518–528

    CAS  Google Scholar 

  • Vance ED, Brookes PC, Jenkinson DS (1987) An extraction method for measuring microbial biomass C. Soil Biol Biochem 19:703–707

    Article  CAS  Google Scholar 

  • Villar MC, Petrikova V, Diaz-Ravina M, Carballis T (2004) Changes in soil microbial biomass and aggregate stability following burning and soil rehabilitation. Geoderma 122:73–82

    Article  CAS  Google Scholar 

  • Wardle DA, Ghani A (1995) A critique of the microbial metabolic quotient (qCO2) as a bioindicator of disturbance and ecosystem development. Soil Biol Biochem 27:1601–1610

    Article  CAS  Google Scholar 

  • Yoder RE (1936) A direct method of aggregate analysis and a study of the physical nature of soil erosion losses. Agron J 28:337–351

    Article  CAS  Google Scholar 

  • Zhou LX, Yang H, Shen QR, Wong MH, Wong JWC (2000) Fractionation and characterization of dissolved organic matter derived from sewage sludge and composted sludge. Environ Technol 21:765–771

    Article  Google Scholar 

  • Zucconi F, Monaco A, Forte M, De Bertoldi M (1985) Phytotoxins during the stabilization of organic matter. In: Gasser JKR (ed) Composting of agricultural and other wastes. Elsevier, London

    Google Scholar 

Download references

Acknowledgements

We thank technical staff at Alcoa for excavating and transporting bauxite residue sand to the laboratory, Katheryn Raymont for assistance with C and N analysis and David Appleton of the School of Land, Crop and Food Sciences Analytical Group for analysis of cations, metals and mineral N.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Richard J. Haynes.

Additional information

Responsible editor: Henner Hollert

Rights and permissions

Reprints and permissions

About this article

Cite this article

Jones, B.E.H., Haynes, R.J. & Phillips, I.R. Influence of organic waste and residue mud additions on chemical, physical and microbial properties of bauxite residue sand. Environ Sci Pollut Res 18, 199–211 (2011). https://doi.org/10.1007/s11356-010-0364-5

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11356-010-0364-5

Keywords

Navigation