References
Alejano LR, Muralha J, Ulusay R, Li CC, Pérez-Rey I, Karakul H, Chryssanthakis P, Aydan Ö (2018) ISRM suggested method for determining the basic friction angle of planar rock surfaces by means of tilt tests. Rock Mech Rock Eng 51:3853–3859
Amiri Hossaini K, Babanouri N, Karimi Nasab S (2014) The influence of asperity deformability on the mechanical behavior of rock joints. Int J Rock Mech Min Sci 70:154–161
Asadi MS, Rasouli V, Barla G (2013) A laboratory shear cell used for simulation of shear strength and asperity degradation for rough rock fractures. Rock Mech Rock Eng 45:649–675
Asadollahi P, Tonon F (2010) Constitutive model for rock fractures: Revisiting Barton’s empirical model. Eng Geol 113:11–32
Atapour H, Moosavi M (2014) The influence of shearing velocity on shear behavior of artificial joints. Rock Mech Rock Eng 47:1745–1761
Barton N (1976) The shear strength of rock and rock joints. Int J Rock Mech Min Sci Geomech Abstr 13:255–279
Barton N, Choubey V (1977) The shear strength of rock joints in theory and practice. Rock Mech Rock Eng 10:1–54
Belem T, Souley M, Homand F (2007) Modeling surface roughness degradation of rock joint wall during monotonic and cyclic shearing. Acta Geotech 2:227–248
Chen X, Li JC, Cai MF, Zou Y, Zhao J (2015) Experimental study on wave propagation across a rock joint with rough surface. Rock Mech Rock Eng 48:2225–2234
Erguler ZA, Ulusay R (2009) Water-induced variations in mechanical properties of clay-bearing rocks. Int J Rock Mech Min Sci 46:355–370
Feucht LJ, Logan JM (1990) Effects of chemically active solutions on shearing behavior of a sandstone. Tectonophysics 175:159–176
Ghazvinian AH, Azinfar MJ, Geranmayeh Vaneghi R (2012) Importance of tensile strength on the shear behavior of discontinuities. Rock Mech Rock Eng 45:349–359
Gökceoğlu C, Ulusay R, Sönmez H (2000) Factors affecting the durability of selected weak and clay-bearing rocks from Turkey, with particular emphasis on the influence of the number of drying and wetting cycles. Eng Geol 57:215–237
Goodman RE (1976) Methods of geological engineering in discontinuous rock. West, New York
Grasselli G (2006) Manuel rocha medal recipient shear strength of rock joints based on quantified surface description. Rock Mech Rock Eng 39:295–314
Gutierrez M, Øino LE, Høeg K (2000) The effect of fluid content on the mechanical behaviour of fractures in chalk. Rock Mech Rock Eng 33:93–117
Hale PA, Shakoor A (2003) A laboratory investigation of the effects of cyclic heating and cooling, wetting and drying, and freezing and thawing on the compressive strength of selected sandstones. Environ Eng Geosci 9:117–130
Horn HM, Deere DU (1962) Frictional characteristics of minerals. Géotechnique 12:319–335
Hua W, Dong S, Li Y, Wang Q (2016) Effect of cyclic wetting and drying on the pure mode II fracture toughness of sandstone. Eng Fract Mech 153:143–150
Hua W, Dong S, Li Y, Xu J, Wang Q (2015) The influence of cyclic wetting and drying on the fracture toughness of sandstone. Int J Rock Mech Min Sci 78:331–335
Hua W, Dong S, Peng F, Li K, Wang Q (2017) Experimental investigation on the effect of wetting-drying cycles on mixed mode fracture toughness of sandstone. Int J Rock Mech Min Sci 93:242–249
**g L, Stephansson O, Nordlund E (1993) Study of rock joints under cyclic loading conditions. Rock Mech Rock Engng 26:215–232
Karami A, Stead D (2008) Asperity degradation and damage in the direct shear test: a hybrid fem/dem approach. Rock Mech Rock Eng 41:229–266
Khamrat S, Thongprapha T, Fuenkajorn K (2018) Thermal effects on shearing resistance of fractures in Tak granite. J Struct Geol 111:64–74
Khanlari G, Abdilor Y (2015) Influence of wet–dry, freeze–thaw, and heat–cool cycles on the physical and mechanical properties of Upper Red sandstones in central Iran. Bull Eng Geol Environ 74:1287–1300
Kleepmek M, Khamrat S, Thongprapha T, Fuenkajorn K (2016) Displacement velocity effects on rock fracture shear strengths. J Struct Geol 90:48–60
Li JC, Li HB, Jiao YY, Liu YQ, **a X, Yu C (2014a) Analysis for oblique wave propagation across filled joints based on thin-layer interface model. J Appl Geophys 102:39–46
Li JC, Li HB, Zhao J (2014b) Study on wave propagation across a single rough fracture by the modified thin-layer interface model. J Appl Geophys 110:106–114
Li JC, Li NN, Li HB, Zhao J (2017) An SHPB test study on wave propagation across rock masses with different contact area ratios of joint. Int J Impact Eng 105:109–116
Li JC, Liu TT, Li HB, Liu YQ, Liu B, **a X (2015) Shear wave propagation across filled joints with the effect of interfacial shear strength. Rock Mech Rock Eng 48:1547–1557
Li Y, Wu W, Tang C, Liu B (2019) Predicting the shear characteristics of rock joints with asperity degradation and debris backfilling under cyclic loading conditions. Int J Rock Mech Min Sci 120:108–118
Lin ML, Jeng FS, Tsai LS, Huang TH (2005) Wetting weakening of tertiary sandstones—microscopic mechanism. Environ Geol 48:265–275
Liu X, ** M, Li D, Zhang L (2018) Strength deterioration of a Shaly sandstone under dry–wet cycles: a case study from the Three Gorges Reservoir in China. Bull Eng Geol Environ 77:1607–1621
Maksimović M (1996) The shear strength components of a rough rock joint. Int J Rock Mech Min Sci Geomech Abstr 33:769–783
Masuda K, Arai T, Fujimoto K, Takahashi M, Shigematsu N (2012) Effect of water on weakening preceding rupture of laboratory-scale faults: Implications for long-term weakening of crustal faults. Geophys Res Lett. https://doi.org/10.1029/2011GL050493
Mehrishal S, Sharifzadeh M, Shahriar K, Song J-J (2016) An experimental study on normal stress and shear rate dependency of basic friction coefficient in dry and wet limestone joints. Rock Mech Rock Eng 49:4607–4629
Mohtarami E, Baghbanan A, Akbariforouz M, Hashemolhosseini H, Asadollahpour E (2018) Chemically dependent mechanical properties of natural andesite rock fractures. Can Geotech J 55:881–893
Momeni A, Hashemi SS, Khanlari GR, Heidari M (2017) The effect of weathering on durability and deformability properties of granitoid rocks. Bull Eng Geol Environ 76:1037–1049
Özbek A (2014) Investigation of the effects of wetting–drying and freezing–thawing cycles on some physical and mechanical properties of selected ignimbrites. Bull Eng Geol Environ 73:595–609
Pappalardo G (2018) First results of infrared thermography applied to the evaluation of hydraulic conductivity in rock masses. Hydrogeol J 26:417–428
Pardini G, Guidi GV, Pini R, Regüés D, Gallart F (1996) Structure and porosity of smectitic mudrocks as affected by experimental wetting—drying cycles and freezing—thawing cycles. CATENA 27:149–165
Park JW, Song JJ (2013) Numerical method for the determination of contact areas of a rock joint under normal and shear loads. Int J Rock Mech Min Sci 58:8–22
Pellet FL, Keshavarz M, Boulon M (2013) Influence of humidity conditions on shear strength of clay rock discontinuities. Eng Geol 157:33–38
Saeb S, Amadei B (1992) Modelling rock joints under shear and normal loading. Int J Rock Mech Min Sci Geomech Abstr 29:267–278
Souley M, Homand F, Amadei B (1995) An extension to the Saeb and Amadei constitutive model for rock joints to include cyclic loading paths. Int J Rock Mech Min Sci Geomech Abstr 32:101–109
Sun Q, Zhang Y (2019) Combined effects of salt, cyclic wetting and drying cycles on the physical and mechanical properties of sandstone. Eng Geol 248:70–79
Török Á, Vásárhelyi B (2010) The influence of fabric and water content on selected rock mechanical parameters of travertine, examples from Hungary. Eng Geol 115:237–245
Tang H, Wasowski J, Juang CH (2019a) Geohazards in the three Gorges Reservoir Area, China——Lessons learned from decades of research. Eng Geol 261:105267
Tang S (2018) The effects of water on the strength of black sandstone in a brittle regime. Eng Geol 239:167–178
Tang ZC (2020) Experimental investigation on temperature-dependent shear behavior of granite discontinuity. Rock Mech Rock Eng 53(9):4043–4060
Tang ZC, Jiao YY, Wong LNY, Wang XC (2016) Choosing appropriate parameters for develo** empirical shear strength criterion of rock joint: Review and new insights. Rock Mech Rock Eng 49:4479–4490
Tang ZC, Zhang QZ, Peng J (2020) Effect of thermal treatment on the basic friction angle of rock joint. Rock Mech Rock Eng 53(4):1973–1990
Tang ZC, Zhang QZ, Peng J, Jiao YY (2019b) Experimental study on the water-weakening shear behaviors of sandstone joints collected from the middle region of Yunnan province, P.R. China. Eng Geol 258:105161
Ulusay R, Karakul H (2016) Assessment of basic friction angles of various rock types from Turkey under dry, wet and submerged conditions and some considerations on tilt testing. Bull Eng Geol Environ 75:1683–1699
Van Eeckhout EM (1976) The mechanisms of strength reduction due to moisture in coal mine shales. Int J Rock Mech Min Sci Geomech Abstr 13:61–67
Wong LNY, Maruvanchery V, Liu G (2016) Water effects on rock strength and stiffness degradation. Acta Geotech 11:713–737
**a CC, Tang ZC, **ao WM, Song YL (2014) New peak shear strength criterion of rock joints based on quantified surface description. Rock Mech Rock Eng 47:387–400
**e K, Jiang D, Sun Z, Chen J, Zhang W, Jiang X (2018) NMR, MRI and AE statistical study of damage due to a low number of wetting–drying cycles in sandstone from the three gorges reservoir area. Rock Mech Rock Eng 51:3625–3634
Zhang BY, Zhang JH, Sun GL (2015) Deformation and shear strength of rockfill materials composed of soft siltstones subjected to stress, cyclical drying/wetting and temperature variations. Eng Geol 190:87–97
Zhang Z, Jiang Q, Zhou C, Liu X (2014) Strength and failure characteristics of Jurassic Red-Bed sandstone under cyclic wetting–drying conditions. Geophys J Int 198:1034–1044
Zhao Y, Ren S, Jiang D, Liu R, Wu J, Jiang X (2018) Influence of wetting-drying cycles on the pore structure and mechanical properties of mudstone from Simian Mountain. Constr Build Mater 191:923–931
Zhao Z, Yang J, Zhang D, Peng H (2017a) Effects of wetting and cyclic wetting–drying on tensile strength of sandstone with a low clay mineral content. Rock Mech Rock Eng 50:485–491
Zhao Z, Yang J, Zhou D, Chen Y (2017b) Experimental investigation on the wetting-induced weakening of sandstone joints. Eng Geol 225:61–67
Zheng B, Qi S (2016) A new index to describe joint roughness coefficient (JRC) under cyclic shear. Eng Geol 212:72–85
Zhou Z, Cai X, Chen L, Cao W, Zhao Y, **ong C (2017) Influence of cyclic wetting and drying on physical and dynamic compressive properties of sandstone. Eng Geol 220:1–12
Zhou Z, Cai X, Ma D, Chen L, Wang S, Tan L (2018) Dynamic tensile properties of sandstone subjected to wetting and drying cycles. Constr Build Mater 182:215–232
Acknowledgements
The authors gratefully acknowledge the supports of the Natural Science Foundation of China (Grant Nos. 41672302, 41977213, and 41672286), and the Opening fund of State Key Laboratory of Geohazard Prevention and Geoenvironment Protection (Chengdu University of Technology) (Grant No. SKLGP2018K018).
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
Conflict of Interest
The authors declare that they have no conflicts of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Tang, Z.C., Zhang, Q.Z. & Zhang, Y. Cyclic Drying–Wetting Effect on Shear Behaviors of Red Sandstone Fracture. Rock Mech Rock Eng 54, 2595–2613 (2021). https://doi.org/10.1007/s00603-021-02413-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00603-021-02413-2