Abstract
The strain fields can be determined on the surface of fiber-reinforced composites by correlation analysis of X-ray radiographs of the specimen. One radiograph is taken of the specimen in an unloaded state and another radiograph of the same specimen is taken in a deformed state. Each radiograph is then imaged by a video camera and digitized using a Matrox digitization board. The displacement map is obtained from the two radiographs by dividing one image into subsets of 20 pixels by 20 pixels and using a correlation algorithm to identify the corresponding subsets in the second image. The correlation is completed between patterns of the grey-level intensities for each subset. The appropriate discrete derivatives can then be evaluated by first difference taken to form the in-plane strains.
The X-ray radiographs correlation analysis strain-field method outlined above was applied to a uniaxially loaded [90, 0] s Gl-Ep coupon. Simultaneously, an extensometer measured the average longitudinal strain over a 2.54-cm (1-in.) gage length. The error between the two methods was less than three percent of the applied strain of 1.3 percent. The same specimen was impacted and re-examined. A radical shift in the strain field was observed when the specimen was reloaded. Further investigation showed the method reliable down to 0.5-percent strain.
Similar content being viewed by others
References
Peters, W.H., Ranson, W.F., Sutton, M.A., Chu, T.C. and Anderson, J., “Application of Digital Correlation Methods to Rigid Bodv Mechanics,” Opt. Eng.,22 (6), (Nov./Dec. 1983).
Chu, T.C., Ranson, W.F., Sutton, M.A. and Peters, W.H., “Applications of Digital-Image Correlation Techniques to Experimental Mechanics,” Experimental Mechanics,25 (3), (Sept. 1985).
Poplin, W.M., Walker, D.M., Peters, W.H., Sutton, M.A. and Ranson, W.F., “Whole Field Experimental Displacement Analysis of Composite Cylinders”, Proc. SEM 1985 Spring Conf. on Exp. Mech., SEM (1985).
Reifsnider, K.L. and Highsmith, A., “The Relationship of Stiffness Changes in Composites Laminates to Fracture-Related Damage Mechanisms,” Fracture of Composite Materials (1981).
O'Brien, T.K. and Reifsnider, K.L., “Fatigue Damage Evaluation Through Stiffness Measurements in Boron-Epoxy Laminates,” J. Comp. Mat.,15 (Jan. 1981).
O'Brien, T.K., “Analysis of Local Delaminations and their Influence on Composite Behavior,” ASTM Symp. on Delamination and Debonding of Materials, Pittsburgh, PA (Nov. 1983).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Russell, S.S., Sutton, M.A. Strain-field analysis acquired through correlation of X-ray radiographs of a fiber-reinforced composite laminate. Experimental Mechanics 29, 237–240 (1989). https://doi.org/10.1007/BF02321382
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF02321382