Abstract
This paper presents a study of nonaqueous suspensions based on ZrO2–8 mol % Y2O3 (8YSZ) powders and describes the use of the powders for producing thin-film coatings on a La2NiO4 (LNO) substrate by electrophoretic deposition (EPD). Stable suspensions for EPD have been prepared using 8YSZ powders differing in morphology and particle size: nanopowder (YSZ_L) produced by a laser evaporation–condensation process and commercially available powder (YSZ_T) (Tosoh, Japan). Ultrasonic processing has been found to have different effects on the particle size composition of the YSZ_L and YSZ_T suspensions. The two types of suspension have been shown to differ significantly in the kinetics of the deposition current at constant voltage: during deposition from the YSZ_L suspension, the current was observed to rise, whereas in the case of the YSZ_T suspension the current decreased markedly with deposition time. The YSZ_L film has been shown to be denser than the YSZ_T film. After sintering at 1350°C, it consisted of completely formed grains ranging in size from 1 to 5 μm. To remove surface pores in YSZ_T coatings, they should be sintered at a temperature of 1450°C.
Similar content being viewed by others
REFERENCES
Besra, L. and Liu, M., A review on fundamentals and applications of electrophoretic deposition (EPD), Prog. Mater. Sci., 2007, vol. 52, pp. 1–61. https://doi.org/10.1016/j.pmatsci.2006.07.001
Corni, I., Ryan, M.P., and Boccaccini, A.R., Electrophoretic deposition: from traditional ceramics to nanotechnology, J. Eur. Ceram. Soc., 2008, vol. 28, pp. 1353–1367. https://doi.org/10.1016/j.jeurceramsoc.2007.12.011
Pikalova, E. and Kalinina, E., Place of electrophoretic deposition among thin-film methods adapted to the solid oxide fuel cell technology: a short review, Int. J. Energy Prod. Manage., 2019, vol. 4, no. 1, pp. 1–27. https://doi.org/10.2495/EQ-V4-N1-1-27
Will, J., Hruschka, M.M., Gubler, L., and Gauckler, L.J., Electrophoretic deposition of zirconia on porous anodic substrates, J. Am. Ceram. Soc., 2001, vol. 84, no. 2, pp. 328–332. https://doi.org/10.1111/j.1151-2916.2001.tb00658.x
Chen, F. and Liu, M., Preparation of Yttria-Stabilised Zirconia (YSZ) Films on La0.85Sr0.15MnO3 (LSM) and LSM–YSZ Substrate Using An Electrophoretic Deposition (EPD) Process, J. Eur. Ceram. Soc., 2001, vol. 21, pp. 127–134. https://doi.org/10.1016/S0955-2219(00)00195-3
Xu, Z., Rajaram, G., Sankar, J., and Pai, D., Electrophoretic Deposition of YSZ Electrolyte Coatings for SOFCs, Fuel Cells Bull., 2007, no. 3, pp. 12–16. https://doi.org/10.1016/S1464-2859(07)70114-1
Das, D., Bagchi, B., and Basu, R.N., Nanostructured zirconia thin film fabricated by electrophoretic deposition technique, J. Alloys Compd., 2017, vol. 693, pp. 1220–1230. https://doi.org/10.1016/j.jallcom.2016.10.088
Kalinina, E.G., Efimov, A.A., and Safronov, A.P., The influence of nanoparticle aggregation on formation of ZrO2 electrolyte thin films by electrophoretic deposition, Thin Solid Films, 2016, vol. 612, pp. 66–71. https://doi.org/10.1016/j.tsf.2016.05.039
Pikalova, E.Yu. and Kalinina, E.G., electrophoretic deposition in the solid oxide fuel cell technology: fundamentals and recent advances, Renew. Sust. Energ. Rev., 2019, vol. 116, paper 109440. https://doi.org/10.1016/j.rser.2019.109440
Kalinina, E.G. and Pikalova, E.Yu., New trends in the development of electrophoretic deposition method in the solid oxide fuel cell technology: theoretical approaches, experimental solutions and development prospects, Russ. Chem. Rev., 2019, vol. 88, no. 12, pp. 1179–1219. https://doi.org/10.1070/RCR4889
Kotov, Yu.A., Osipov, V.V., Ivanov, M.G., Samatov, O.M., Platonov, V.V., Lisenkov, V.V., Murzakayev, A.M., Medvedev, A.I., Azarkevich, E.I., Shtolz, A.K., and Timoshenkova, O.R., Properties of YSZ and CeGdO nanopowders prepared by target evaporation with a pulse-repetitive CO2-laser, Rev. Adv. Mater. Sci., 2003, vol. 5, pp. 171–177.
Pikalova, E.Yu., Nikonov, A.V., Zhuravlev, V.D., Bamburov, V.G., Samatov, O.M., Lipilin, A.S., Khrustov, V.R., Nikolaenko, I.V., Plaksin, S.V., and Molchanova, N.G., Effect of the synthesis technique on the physicochemical properties of Ce0.8(Sm0.75Sr0.2Ba0.05)0.2O2 – δ, Inorg. Mater., 2011, vol. 47, no. 4, pp. 396–401. https://doi.org/10.1134/S0020168511040170
Boehm, E., Bassat, J.-M., Dordor, P., Mauvy, F., Grenier, J.-C., and Stevens, Ph., Oxygen diffusion and transport properties in non-stoichiometric Ln2– xNiO4 + δ oxides, Solid State Ionics, 2005, vol. 176, pp. 2717–2725. https://doi.org/10.1016/j.ssi.2005.06.033
Shen, Y., Zhao, H., Liu, X., and Xu, N., Preparation and electrical properties of Ca-doped La2NiO4 + δ cathode materials for IT-SOFC, Phys. Chem. Chem. Phys., 2010, vol. 12, pp. 15124–15131. https://doi.org/10.1039/C0CP00261E
Kolchugin, A.A., Pikalova, E.Yu., Bogdanovich, N.M., Bronin, D.I., Pikalov, S.M., Plaksin, S.V., Ananyev, M.V., and Eremin, V.A., Structural, electrical and electrochemical properties of calcium-doped lanthanum nickelate, Solid State Ionics, 2016, vol. 288, pp. 48–53. https://doi.org/10.1016/j.ssi.2016.01.035
Kalinina, E.G., Pikalova, E.Yu., Menshikova, A.V., and Nikolaenko, I.V., Electrophoretic deposition of a self-stabilizing suspension based on a nanosized multicomponent electrolyte powder prepared by the laser evaporation method, Solid State Ionics, 2016, vol. 288, pp. 110–114. https://doi.org/10.1016/j.ssi.2015.12.008
Kalinina, E.G., Pikalova, E.Yu., Kolchugin, A.A., Pikalov, S.M., and Kaigorodov, A.S., Cyclic electrophoretic deposition of electrolyte thin-films on the porous cathode substrate utilizing stable suspensions of nanopowders, Solid State Ionics, 2017, vol. 302, pp. 126–132.https://doi.org/10.1016/j.ssi.2017.01.016
Gregg, S.J. and Sing, K.S.W., Adsorption, Surface Area and Porosity, New York: Academic, 1982, p. 304.
Kalinina, E.G., Pikalova, E.Yu., Zhuravlev, V.D., Shcherbinin, S.V., and Safronov, A.P., Aggregatively stable suspensions of micrometer powders of doped barium cerate for electrophoretic deposition of thin-film coatings of solid-oxide fuel cells, Russ. J. Appl. Chem., 2017, vol. 90, no. 6, pp. 862–869. https://doi.org/10.1134/S1070427217060052
Bhattacharjee, S., DLS and zeta potential – what they are and what they are not?, J. Controlled Release, 2016, vol. 235, pp. 337–351. https://doi.org/10.1016/j.jconrel.2016.06.017
Stotz, S., Field dependence of the electrophoretic mobility of particles suspended in low-conductivity liquids, J. Colloid Interface Sci., 1978, vol. 65, no. 1, pp. 118–130. https://doi.org/10.1016/0021-9797(78)90264-3
Koelmans, H. and Overbeek, J.T.G., Stability and electrophoretic deposition of suspensions in non-aqueous media, Discuss. Faraday Soc., 1954, vol. 18, pp. 53–63. https://doi.org/10.1039/df9541800052
ACKNOWLEDGMENTS
We are grateful to A.P. Safronov (Ural Federal University, Yekaterinburg) for his assistance in determining the particle size in the suspensions and to A.A. Kudryavtsev (OOO Teskan, St. Petersburg) and A.S. Farlenkov (Institute of High-Temperature Electrochemistry, Ural Branch, Russian Academy of Sciences, Yekaterinburg) for performing the microstructural work.
Part of this work was carried out using equipment at the Shared Research Facilities Center, Institute of Electrophysics, Ural Branch, Russian Academy of Sciences, and at the Composition of Compounds Shared Access Center, Institute of High-Temperature Electrochemistry, Ural Branch, Russian Academy of Sciences.
Funding
This work was supported by the Russian Federation Ministry of Science and Higher Education (state research target for the Institute of Electrophysics, Ural Branch, Russian Academy of Sciences; SOFC Technology Development subject area at the Institute of High-Temperature Electrochemistry, Ural Branch, Russian Academy of Sciences).
We gratefully acknowledge the comprehensive support of the Russian Federation Government (02.A03.21.0006, Act 211).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by O. Tsarev
Rights and permissions
About this article
Cite this article
Kalinina, E.G., Pikalova, E.Y. Preparation and Properties of Stable Suspensions of ZrO2–Y2O3 Powders with Different Particle Sizes for Electrophoretic Deposition. Inorg Mater 56, 941–948 (2020). https://doi.org/10.1134/S0020168520090095
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0020168520090095