Abstract
The adsorption kinetics of activated carbon (AC)–type adsorbent materials, which were prepared from a by-product of African palm (shells) processing by chemical activation with dehydrating metal salts at two different concentrations, was studied. N2 physisorption was performed in order to determine the textural characteristics of the adsorbent solids, obtaining materials with BET areas between 721 and 1334 m2g−1 and micropore volumes between 0.33 and 0.55 cm3g−1; FTIR determination was also used as a chemical characterization technique in order to observe variations in the functional groups present. CO2 adsorption was determined, obtaining values between 175 and 274 mg∙g−1; these results are correlated with the physicochemical characteristics of the materials. With the experimental data obtained in this adsorption, the kinetic study was carried out taking into account the kinetic models of pseudo-first-order, pseudo-second-order, and intraparticle diffusion, showing a better adjustment to this last model of a physisorption process. Finally, CO2 adsorption calorimetry was performed on the two adsorbents that presented the highest adsorption capacities, evidencing variations in the characteristics of the activated carbons with the change of the impregnant used. A correlation is observed between the speed of the CO2 adsorption process and the adsorption capacity.
Similar content being viewed by others
Data availability
The authors confirm that the data supporting the findings of this study are available within the article and extra information can be obtained by emailing the corresponding author, upon reasonable request.
References
Al-Ghouti MA, Da’ana DA (2020) Guidelines for the use and interpretation of adsorption isotherm models: a review. J Hazard Mater 393:122383. https://doi.org/10.1016/j.jhazmat.2020.122383
Álvarez-Gutiérrez N, Gil MV, Rubiera F, Pevida C (2017) Kinetics of CO2 adsorption on cherry stone-based carbons in CO2 /CH4 separations. J Chem Eng 307:249–257. https://doi.org/10.1016/j.cej.2016.08.077
Brunauer S, Emmet PH, Teller E (1938) Adsorption of gases in multimolecular layers. J Am Chem Soc 60:309–319. https://doi.org/10.1021/ja01269a023
Condon JB (2006) Measuring the physisorption isotherm. En: Surface area and porosity. Determination by Phisisorption. Elsevier Science:29–44. https://doi.org/10.1016/B978-0-444-51964-1.X5000-6
Donni A, Wan MA, Wan D, Mohd KA (2007) Production of carbon molecular sieves from palm shell based activated carbon by pore sizes modification with benzene for methane, selective separation. Fuel Process Technol 88:599–605
Durán-Valle CJ, Gómez-Corzo M, Pastor-Villegas J, Gómez-Serrano V (2005) Study of cherry stones as raw material in preparation of carbonaceous adsorbents. J Anal Appl Pyrolysis 73:59–67. https://doi.org/10.1016/j.jaap.2004.10.004
Fan X, Li C, Zeng G, Gao Z, Chen L, Zhang W, Gao H (2010) Removal of gas-phase element mercury by activated carbon fiber impregnated with CeO2. Energy Fuels 24:4250–4254. https://doi.org/10.1021/ef100377f
García V (2009) Diseño, construcción y puesta a punto de un micro calorímetro de adsorción. Universidad de San Luis. Argentina. Tesis de Maestria
Garcia V, Moreno-Piraján JC, Giraldo-Gutiérrez L, Sapag K, Zgrablich G (2009) A new microcalorimeter of adsorption for the determination of differential enthalpies. Micropor Mesopor Mat 120:239–245. https://doi.org/10.1155/2008/127328
Garrido J, Linares-Solano A, Martín-Martinez JM, Molina-Sabio M, Rodriguez-Reinoso F, Torregrosa R (1987) Use of N2 vs. CO2 in the characterization of activated carbons. Langmuir 3:76–81. https://doi.org/10.1021/la00073a013
González-García P (2018) Activated carbon from lignocellulosics precursors: a review of the synthesis methods, characterization techniques and applications. Renew Sustain Energy Rev 82:1393–1414. https://doi.org/10.1016/j.rser.2011.07.073
He S, Chen G, **ao H, Shi G, Ruan C, Ma Y, Dai H, Yuan B, Chen X, Yang X (2021) Facile preparation of N-doped activated carbon produced from rice husk for CO2 capture. J Colloid Interface Sci 582:90–101. https://doi.org/10.1016/j.jcis.2020.08.021
Jung S, Oh S, Choi G, Kim J (2014) Production and characterization of microporous activated carbons and metallurgical bio-coke from waste shell biomass. J Anal Appl Pyrolysis 109:123–131. https://doi.org/10.1016/j.jaap.2014.07.003
Kohl S, Drochner A, Vogel H (2010) Quantification of oxygen surface groups on carbon materials via diffuse reflectance FT-IR spectroscopy and temperature programmed desorption. Catal Today 150:67–70. https://doi.org/10.1016/j.cattod.2009.05.016
Lan X, Jiang X, Song Y, **g X, **ng X (2019) The effect of activation temperature on structure and properties of blue coke-based activated carbon by CO2 activation, green process. Synth 8:837–845. https://doi.org/10.1515/gps-2019-0054
Landers J, Gor GY, Neimark AV (2013) Density functional theory methods for characterization of porous materials. Colloid Surfaces a: Physicochem Eng Aspects 437:3–32. https://doi.org/10.1016/j.colsurfa.2013.01.007
Li D, Liu Q, Weniger P, Gensterblum Y, Busch A, Krooss BM (2010) High-pressure sorption isotherms and sorption kinetics of CH4 and CO2 on coals. Fuel. 89:569–580. https://doi.org/10.1016/j.fuel.2009.06.008
Mallesh D, Anbarasan J, Mahesh Kumar P, Upendar K, Chandrashekar P, Rao BV, Lingaiah N (2020) Synthesis, characterization of carbon adsorbents derived from waste biomass and its application to CO2 capture. Appl Surf Sci 530:147226
Marsh H, Rodriguez-Reinoso F (2005) Characterization of activated carbon. En: Activated carbon. Elsevier Science Ltd. pp. 157–164
Melouki R, Ouadah A, Llewellyn PL (2020) The CO2 adsorption behavior study on activated carbon synthesized from olive waste. J CO2 Util 42:101292. https://doi.org/10.1016/j.jcou.2020.101292
Mohd N, Buthiyappan A, Ra A, Muhamad FAP, Suriati S (2022) Recent advances in biomass based activated carbon for carbon dioxide capture – a review. J Ind Eng Chem 116:1–20. https://doi.org/10.1016/j.jiec.2022.08.021
Nasri NS, Hamza UD, Ismail SN, Ahmed MM, Mohsin R (2014) Assessment of porous carbons derived from sustainable palm solid waste for carbon dioxide capture. J Cleaner Prod 71:148–157. https://doi.org/10.1016/j.jclepro.2013.11.053
Nayak A, Bhushan B, Gupta V, Sharma P (2017) Chemically activated carbon from lignocellulosic wastes for heavy metal wastewater remediation: effect of activation conditions. J Colloid Interface Sci 493:228–240. https://doi.org/10.1016/j.jcis.2017.01.031
Nazir G, Rehman A, Park SJ (2021) Role of heteroatoms (nitrogen and sulfur)-dual doped corn-starch based porous carbons for selective CO2 adsorption and separation. J CO2 Util 51:101641. https://doi.org/10.1016/j.jcou.2021.101641
Pu Q, Zou J, Wang J, Lu S, Ning P, Huang L, Wang Q (2021) Systematic study of dynamic CO2 adsorption on activated carbons derived from different biomass. J Alloys Compd 887:161406. https://doi.org/10.1016/j.jallcom.2021.161406
Sahoo S (2022) Experimental investigation on different activated carbons as adsorbents for CO2 capture. Therm Sci Eng Prog 33:101339. https://doi.org/10.1016/J.TSEP.2022.101339
Serafin J, Cruz OF (2022) Promising activated carbons derived from common oak leaves and their application in CO2 storage. J Environ Chem Eng 10:107642. https://doi.org/10.1016/j.jece.2022.107642
Serafin J, Sreńscek-Nazzal J, Kamińska A, Paszkiewicz O, Michalkiewicz B (2022) Management of surgical mask waste to activated carbons for CO2 capture. J CO2 Util 59:101970. https://doi.org/10.1016/j.jcou.2022.101970
Sibera D, Srenscek-Nazza J, Morawski WA, Michalkiewicz B, Serafin J, Wrobel RJ, Narkiewicz U (2018) Microporous carbon spheres modified with EDA used as carbon dioxide sorbents. Adv Mater Lett 9(432):435. https://doi.org/10.5185/amlett.2018.1872
Soares DA, Alexandre de Oliveira JC, Nazzarro MS, Sapag KM, López RH, Lucena SMP, Azevedo DCS (2018) CO2 gas-adsorption calorimetry applied to the study of chemically activated carbons. Chem Eng Res Des 136:753–760. https://doi.org/10.1016/j.cherd.2018.06.034
Thommes M, Kaneko K, Neimark AV, Olivier JP, Rodriguez-reinoso F, Rouquerol J, Sing KSWW (2015) Physisorption of gases, with special reference to the evaluation of surface area and pore size distribution (IUPAC Technical Report). Pure Appl Chem 87:1051–1069. https://doi.org/10.1515/pac-2014-1117
Funding
Ministry of Science, Technology and Innovation (Minciencias, Colombia).
Author information
Authors and Affiliations
Contributions
Sergio Acevedo: conceptualization, investigation, writing original draft, experimental procedures, data acquisition and analysis, writing, review, and editing. Liliana Giraldo: result analysis, writing, review, and editing. Juan C. Moreno-Piraján: result analysis, writing, review, and editing. All authors have seen and agree with the contents of the manuscript.
Corresponding author
Ethics declarations
Conflict of interest
The authors declare no conflict of interest.
Additional information
Responsible Editor: Guilherme L. Dotto
Publisher's note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
The authors certify that the submission is original work and is not under review at any other publication.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Acevedo, S., Giraldo, L. & Moreno-Piraján, J.C. Kinetic study of CO2 adsorption of granular-type activated carbons prepared from palm shells. Environ Sci Pollut Res 31, 39839–39848 (2024). https://doi.org/10.1007/s11356-023-26423-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11356-023-26423-5