Abstract
In order to study the dynamic mechanical properties of thermally damaged granite under cyclic impact loading, cyclic impact tests were conducted on thermally damaged granite specimens using a Hopkinson compression bar device and a muffle furnace. The effects of the number of cyclic impacts on the mechanical properties and internal structural changes of the thermally damaged granite at different temperature levels were investigated. The results show that: (1) in the dynamic stress–strain curve, both the mechanical strength and the elastic-modulus of rock mass decrease after 400 °C, and the specimen above 400 °C changes from elastic–plastic deformation to brittle deformation. (2) under the action of temperature and axial compression, the peak stress decreases with the increase of cycle times, and the peak stress decreases rapidly with the increase of temperature under the same axial compression, especially after 400 °C, it reaches 30%, the increase of peak stress under axial compression after 400 °C is negligible, which proves that the effect of high temperature on stress is the main part. (3) the internal structure of rock samples at 200 °C and 400 °C is relatively complete, only porosity and cracks appear in the observation of fine structure of rock, while the internal structure of rock samples at 600 °C and 800 °C is obviously damaged, from the initial appearance of micro-cracks and pores to the final appearance of a large number of bulk crystal detachment. For the observation of the macrostructure, the damage of the specimens without axial pressure before 400 °C shows splitting damage, while the specimens with axial pressure show end effect. Specimens above 400°C no longer have the load-bearing capacity but showed broken particles and powder.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Data availability
The data in this article are available, and hereby declare.
References
Ai DH, Zhao YC, Wang QF, Li CW (2019) Experimental and numerical investigation of crack propagation and dynamic properties of rock in SHPB indirect tension test. Int J Impact Eng 126:135–146. https://doi.org/10.1016/j.ijimpeng.2019.01.001
Bieniawski ZT, Hawkes I (1978) Suggested methods for determining tensile strength of rock materials. Int J Rock Mech Min 15(3):99–103. https://doi.org/10.1016/0148-9062(78)90003-7
Dai B, Shan QW, Chen Y, Luo XJ (2022) Mechanical and energy dissipation characteristics of granite under cyclic impact loading. J Cent South Univ 29:116–128. https://doi.org/10.1007/s11771-022-4897-9
Gong FQ, Li XB, Liu XL (2010) Experimental study of dynamic characteristics of sandstone under one-dimensional coupled static and dynamic loads. Chin J Rock Mech Eng 29(10):2076–2085
Gong FQ, Li XB, Rao QH, Liu XL (2013) Reference method for determining sample size in SHPB tests of rock materials. J Vib Shock 32(17):24–28
Hu SS (2005) Progress in the application of Hopkinson’s experimental technique for compression bars. J Exp Mech 20(04):589–594
Hu SR, Peng JC, Huang C, Chen PK, LI M, (2011) An overview of current status and progress in coal mining of the deep over a kilometer. J Chin Min Mag 20(7):105–110
Kan JG, Wang P (2021) Influencing factors of disturbance effects of blasting and driving of deep mine roadway groups. Shock Vib S1:1–13. https://doi.org/10.1155/2021/8873826
Li XB, Zhou ZL, Lok TS, Hong L, Yin TB (2007) Innovative testing technique of rock subjected to coupled static and dynamic loads. Int J Rock Mech Min Sci 45(5):739–748. https://doi.org/10.1016/j.ijrmms.2007.08.013
Li XB, Gong FQ, Gao K, Yin TB (2010) Test study of impact failure of rock subjected to one dimensional coupled static. Chin J Rock Mech Eng Dyn Loads 30(06):1179–1190
Li XB, Zhou J, Wang SF, Liu B (2017) Review and practice of deep mining for solid mineral resources. Chin J Nonferr Met 27(06):1236–1262
Li XX, ** BP, He SX, Cheng ZP, **n GX (2021) Mcroscopic change laws of granite under thermal shock. J Min Res Dev 41(05):67–73
Nara Y (2014) Effect of anisotropy on the long-term strength of granite. Rock Mech Rock Eng 48(3):959–969. https://doi.org/10.1007/s00603-014-0634-5
Shu RH, Yin TB, Li XB, Yin ZQ, Tang LZ (2019) Effect of thermal treatment on energy dissipation of granite under cyclic impact loading. Trans Nonferrous Met Soc 29(02):385–396. https://doi.org/10.1016/S1003-6326(19)64948-4
Song L, Hu SS (2005) Two-wave and three-wave method in SHPB data processing. Explos Shock Waves 25(04):368–373
Wook S, Gyeong J, Woong SP, Kim MS, Obara Y, Cho SH (2019) Anisotropic influence of fracture toughness on loading rate dependency for granitic rocks. Eng Fract Mech 221:106677. https://doi.org/10.1016/j.engfracmech.2019.106677
Wu YC, ** BP, Wang L, Niu XM, Wang S, Zhao YS (2020) Experimental study on physico-mechanical properties of granite after high temperature. J Cent South Univ 51(01):193–203
Wu QZ, Liu XQ, Liu GL, Chen KX, Liu Y (2021) Research on the development status and countermeasures of deep mining of metal mines in China. Min Technol 21(05):23–27
** BP, Wu YC, Zhao YS, Wang L, Zhang BP, Niu XM (2020) Experimental investigations of compressive strength and thermal damage capacity characterization of granite under different cooling modes. Chin J Rock Mech Eng 39(02):287–299
** BP, Wu YC, Wang S, **ong GM, Zhao YS (2022) Evolution of mechanical properties of granite under thermal shock in water with different cooling temperatures. Rock Soil Mech 41(S1):83–94
**e HP (2017) Research framework and anticipated results of deep rock mechanics and mining theory. Adv Eng Sci 49(02):1–16
Xu XC (2003) Study on the characteristics of thermal damage for granite. Rock Soil Mech S2:188–191
Yavuz H, Demirdag S, Caran S (2010) Thermal effect on the physical properties of carbonate rocks. Int J Rock Mech Min 47(1):94–103. https://doi.org/10.1016/j.ijrmms.2009.09.014
Yin TB, Wang P, Li XB, Shu RH, Ye ZY (2016) Effects of thermal treatment on physical and mechanical characteristics of coal rock. J Cent South Univ 23(9):2336–2345. https://doi.org/10.1007/s11771-016-3292-9
Yu Y, Zhang LY, Lu JF, Chen DC (2021) Research on the evolution characteristics of floor stress and reasonable layout of roadways in deep coal mining. Geofluids 5:1–17. https://doi.org/10.1155/2021/6631444
Zhao ZY, Xue JC, ** JF, Tan L, Cai RY, **a WB (2022) Damage analysis of chemically corroded sandstone under cyclic impacts and axial static pressure. Geotech Geol Eng 40(121):2581–2592. https://doi.org/10.1007/S10706-022-02047-3
Zhu JJ, Li XB, Gong FQ, Wang SM (2013) Dynamic characteristics and damage model for rock under uniaxial cyclic impact compressive loads. Chin J Geotech Eng 35(03):531–539
Acknowledgements
The authors are very grateful to editors and reviewers for carefully reading the manuscript and providing valuable suggestions.
Funding
This research was supported financially by the National Natural Science Foundation of China (No. 51664016), Key R&D Program of Jiangxi Province (20212BBG73013) and the Jiangxi Provincial Department of Education (GJJ150694).
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
**a Wenbin, Xue **chun, Zhao Zhuyu, Cai Ruoyan, Zhang Yinbin, ** Jiefang declare that they have no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
**a, W., Xue, J., Zhang, Y. et al. Dynamic Characteristics of Thermal Damage Granite Under Cyclic Impact Loading. Geotech Geol Eng 41, 2313–2323 (2023). https://doi.org/10.1007/s10706-023-02399-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10706-023-02399-4