Introduction

Rice (Oryza sativa Lin.) is the most demanding cereal in the world. It appears as an indispensable food for more than 50% of the world’s population. Its requirement is increasing rapidly for fulfilling the demand of ever growing human population. To meet this rising demand, different approaches are being practised, such as boosting rice production with the application of different fertilizers (Cassman et al. 1998), cultivating high yielding rice varieties and going forward with instructions issued by governments.

The application of nitrogen fertilizer promotes the rice yield, but it also has unfavourable effects on the environment and soil health (Leip et al. 2014). One of the most common steps taken in the direction of maintaining soil health and environment is the use of organic fertilizers. Such fertilizers provide essential nutrients to soil, and also improve other soil properties, such as water-holding capacity, nutrient-holding capacity and microbial activity of soil. However, a huge volume of organic fertilizer is required for achieving potential of high yielding rice varieties, which will directly step up the cost of farming (Baruah and Baruah 2015; Baruah et al. 2016). In addition, the decomposition of an organic matter under humid tropical condition is relatively hasty and its gathering is minimal in upland irrigated soils.

Hence, a balanced approach that can be used to sustainably improve rice yield and soil quality is to apply wastes produced from kitchen, garden and farm (crop residues and farm yard manure) in combination with inorganic fertilizers. The application of such a blended amendment will have a greater chance to endure a fairly lofty amount of nutrients required for a high yielding rice variety and also to improve soil traits. Moreover, composting of eco-friendly organic wastes is a good option to provide a high-quality green fertilizer as a supplement to inorganic fertilizer. The use of compost increases organic carbon and moisture retention ability of soil, while decreases its bulk density. Soil organic carbon and total nitrogen act as basic elements of green agriculture (Franzluebbers and Stuedemann 2009). Hence, restoration of soil organic carbon is required for enhancing rice production by maintaining soil quality, and also to raise the soil carbon store to decrease the release of carbon dioxide from soil. On the other hand, the renewal of nitrogen is desirable for lowering the need of nitrogen fertilizers by avoiding the percolation of nitrogen and release of nitrous oxide to the atmosphere.

Motivated by above, a field trial was undertaken with the rice variety of Naveen in the summer crop** season. With the aim of enhancing rice production, the investigation was concentrated on studying the effects of organic waste-blended inorganic fertilizer on rice growth, soil properties and rice yield. Finally, the cloud of data related to plant growth, soil properties and rice yield were analyzed through statistical tools to identify the soil attributes affecting the yielding of rice.

Materials and methods

Experimental design and field management

A 2-year field trial in the summer rice crop** system was performed on an experimental site inside the Tezpur University Campus (26°41′ N, 92°50′ E) situated in the north bank plain zone of Agroclimatic division of Assam in India. The area is under moist subtropical monsoon climate. The study period was from the last week of February to the third week of June in the years of 2016 and 2017. Before starting the experiment, the physico-chemical properties of the soil were determined using applicable methods.

Two months prior to the starting of the field trial, the compost was prepared using eco-friendly organic waste materials. For this, a mixture was prepared first with kitchen wastes (peels of vegetables and fruits, rotten vegetables, leftover cooked food, used tea leaves, etc.), garden wastes (grasses and bushes) and farm waste (cow dung manure) in the ratio of 1:2:2. Then, the compost was formed by concealing the mixture for 2 months in a ditch under ambient air temperature.

In the field experiment, 6 treatments were replicated 4 times in a random block design (RBD), for which a total of 24 plots were prepared in 4 parallel blocks. Each plot was 2 m × 2 m in size. A gap of 50 cm wide was left between two adjacent plots for preventing intermixing of amendments. The six treatments were marked by T1 through T6 as follows: T1 = No amendment, T2 = NPK (inorganic fertilizer), T3 = NPK + crop residue of 5 t/ha (ton per hectare), T4 = NPK + farm yard manure (FYM) of 5 t/ha, T5 = NPK + FYM of 10 t/ha, and T6 = NPK + compost of 2.5 t/ha. Although the package of practices published by the Government of Assam recommends to apply 10 t/ha FYM during field preparation (Anonymous 2015), treatment T4 was considered to assess the impact of its half (i.e., 5 t/ha). Along with the amendments as per the field layout, urea, single superphosphate (SSP) and muriate of potash (MOP) were applied in the ratio of 60:30:30 as the NPK (inorganic fertilizer). Fifty percent (50%) of the portion of urea was added with the whole portions of SSP and MOP as the basal fertilizer, 25% was applied in the middle of the tillering stage and the remaining 25% was applied in the panicle initiation stage of active vegetative growth of rice. The moisture contents in the organic materials (crop residue, FYM and compost) and the corresponding C:N ratios at the time of the application of the amendments were assessed as (12.70%, 48.97), (46.94%, 14.41) and (35.49%, 10.58), respectively.

Approved seedlings of 35 days old of Naveen rice variety were gathered from the Regional Agriculture Research Station, Nagaon, and they were transplanted manually in row to row of 20 cm × 20 cm and plant to plant spacing of 20 cm with two seedlings per hill. The field was irrigated twice a week as per a scheme of intermittent irrigation. The plots were irrigated in a way to hold 5 cm of standing water until panicles initiated. Manual weeding, application of insecticides and pesticides were also done regularly as per the suggestion set out by the Government of Assam.

Plant sampling and analysis

Plant height is obtained from the plants of three hills selected from three random plots per amendment, excluding the boarder hills of the plots. The plant height was measured from the stem base of a plant to the tip of its longest leaf or panicle, whichever was longer.

In the case of biomass, a destructive sampling of three plants per amendment was collected and removed the stuck soil by washing with water. Separating the roots, shoots and leaves of the plants, they were dried in an oven at 75 ± 2 °C temperature until their constant weights were obtained. Those dried weights were their respective biomass values, i.e., root biomass, shoot biomass and leaf biomass, respectively.

Soil sampling and analysis

For determining the properties of the initial soil, a composite soil sample was prepared by mixing soil samples collected from four different sites of the experimental field. For the properties of the soil after the experiment, another composite soil sample was prepared by collecting soil samples after harvest from three plots per amendment. In both cases, soil samples were obtained from a depth of 0–15 cm using an iron probe of 2 cm diameter.

Soil moisture (SM) content was measured from a portion of each composite sample using the gravimetric method. For obtaining other soil properties, the remaining portion of the composite sample was first dried in open air, then grounded, and finally passed through a sieve having pores 2 mm in size. The concentration of soil organic carbon (SOC) was evaluated through the potassium dichromate oxidation process conceived by Walkly and Black (1934). Total nitrogen (TN) and total carbon (TC) in soil were estimated by a carbon hydrogen nitrogen (CHN) analyser (model: 2400 series 2, USA). The soil catalase activity (CAT) was determined using the method provided by Zhang et al. (2012). The available nitrogen, available phosphorus and available potassium in the soil were evaluated using the method proposed by Page et al. (1982). The iron, copper, manganese and zinc were first extracted by diethylene-triamine-pentaacetic acid (DTPA) and then quantified through a mass spectrophotometer (Model: Perkin Elmer Optima 2100DV).

For obtaining the soil bulk density (BD), three soil cores, each of 15 cm in length and 5 cm in diameter, were taken from plots under each treatment, and dried at 105 °C temperature. Then, BD for each core was calculated by dividing the difference in its initial and dried weights by the core volume. Then, the average of the BD values of the three cores under a treatment is taken as the ultimate BD under the treatment.

Finally, the volumetric water content (VWC) and water-filled pore space were calculated from the obtained SM and BD values using the formula proposed by Brzezinska et al. (2005).

Yield and yield-related parameters

From three random plots under each treatment, an area of 1 m × 1 m was chosen from each plot for determining productive tillers and sterility percentage. The matured grains containing 14% moisture were harvested from the areas, and then the harvest index was calculated using the formula as given by Liu et al. (2013). Further, the panicle length, filled grain and weight of thousand grains were also determined. In addition, using the average yield of 2 years of experimentation, the partial factor productivity and nitrogen agronomic efficiency were calculated through the formulae given by Guo et al. (2, where it is observed that the amendments brought noticeable changes in the growth of the rice plants.

Table 2 Variation in plant morphological attributes (mean ± standard error) under different treatments in a 2-year field experiment in the summer crop** seasons (Tukey’s HSD test at significance level of 5%)
Full size table

The plant height during the crop growth period increased almost equally under all the amendments, recoding the maximum of (106.40 ± 0.30) cm under T2 and the minimum of (80.36 ± 0.31) cm under T1 at the final stage (i.e., at harvest). Treatment T2 contained only NPK, which released nutrients speedily causing the plants to grow faster.

Unlike plant height, the number of tillers per hill showed a growing trend from the tillering stage to the flowering stage and then decreased at the harvest, showing the highest value of 18 ± 0.57 under T6 and the lowest value of 9 ± 0.57 under T1. The result was similar to that of Yung-Yu (2005), where a rice pot experiment was performed with two different composts.

The number of leaves per hill showed a similar trend like the number of tillers per hill, increased from the tillering stage to the flowering and then decreased at the harvest. The maximum of 40 ± 0.33 number of leaves were found under T5 and the minimum of 24 ± 0.33 under T1 at the harvest.

Increasing trend in root length was noticed under T2–T4 and T6 in the period in between the tillering and flowering stages, and under T1, T3 and T5 at the harvest; while a decreasing trend under T2, T4 and T6 at the harvest. Such trends of variation in the root length indicate that the soil faced alternate wetting and drying.

Due the above-stated trends in the growth of the plants, there were significant differences in both above and below ground biomass under different amendments in comparison to those under T1 during the investigation of all the three crop** stages (tillering, flowering and harvest stages). Both above and below ground biomass showed uprising trends from the tillering stage to the flowering stage under all the six treatments; while decreasing trends at the harvest were shown by the above ground biomass under T2 and T4, and by the below ground biomass under T1–T3. Both above and below ground biomass attained their maximum values under T5 and minimum values under T1.

Soil properties

The variations in soil properties at the harvest under different amendments are shown in Table 3, where it is observed that the soil under T6 (compost-blended amendment) had the best/highest values of soil moisture (SM), volumetric water content (VWC), soil catalase activity (CAT), soil organic carbon (SOC), and iron and manganese; while their lowest values occurred in the soil under T1. Also, the best/highest value of pH was found under T6 and its lowest under T3. The soil bulk density was the best/lowest under T6 (also under T5), and the highest under T2. Moreover, the maximum and minimum values of available phosphorus were found under T3 and T4, respectively. Further, T1 showed the lowest values of total nitrogen (TN), total carbon (TC), available nitrogen (N), available phosphorus (P), available potassium (K), zinc and copper also, with their better/highest values occurring under other amendments out of T2–T5. It is to be mentioned that different organic materials, used as composting materials, release different nutrients, e.g., Laos et al. (2000) and Kowalijiow and Mazzarino (2007) found higher release of phosphorus by the compost prepared with fish bio-solid as one of the constituents, and Watanabe et al. (2018) found higher release of total carbon by the compost prepared with straw as one of the constituents.

Table 3 Variation in soil properties under different amendments at the harvest treatments in a 2-year field experiment in the summer crop** seasons (Tukey’s HSD test at significance level of 5%)
Full size table

The best SM and VWC under the compost-blended T6 directly supported the work of Zemanek (2011). The presence of higher SM and VWC in compost enhances the microbial activity, which helps in the growth of crops by releasing easily absorbable nutrients.

The finding of the best bulk density under T6 (also under T5) and the worst under T2 was in the line of the work of (Gudadhe et al. 2015), who reported that the effect of organic blended inorganic fertilizer on bulk density is more pronounced than that of inorganic fertilizer alone. Further, Santhy et al. (1999) also found that the application of organic manure in a blended experiment reduces the bulk density. The fact is that the organic carbon contained in organic materials reduces bulk density when such materials are used as a fertilizer.

As the addition of organic materials to soil channels the accumulation of extra carbon (Bharali et al. 2017; Baruah and Baruah 2015; Kirkby et al. 2013), SOC was found enhanced under T3, T5 and T6, i.e., under the inorganic fertilizer blended with organic materials. The increased SOC helps microbes to provide nutrients to plants by kee** carbon and nitrogen balanced in soil, otherwise microbes would decompose existing organic carbon of the soil (Fontaine et al. 2004; Murphy et al. 2015; Poeplau et al. 2017). The SOC was found increased under inorganic T2 also, which might be due to the fact that the application of urea assimilated carbon by improving leaf, shoot and root biomasses of rice plants (Liu et al. 2017; Ge et al. 2016; Zhu et al. Full size table

Table 6 Evaluation of amendments in the perspective of N partial factor productivity (PFPN), N agronomic efficiency (AEN), increased yield over T2 and yield contribution of N (YCN), using mean data obtained from a 2-year field experiment in the summer crop** seasons
Full size table

To optimize yield, it is necessary to identify the factors which affect the yielding and also the extents of their influences on yielding. However, no acceptable procedure has been established so far to analyze the yield-determining factors. The progression of plants and their net productivity in an ecosystem are usually evaluated by interacting different attributes. In the present study, the method of stepwise regression analysis proposed by Kosaki et al. (1989) was employed for evaluating the soil parameters which significantly contributed on rice yielding. Conducting the analysis with 17 soil parameters, only 2 of them (soil moisture and total carbon) were found affecting the rice yield significantly. About 70.4% variation in yield could be explained by soil moisture and additional 11.4% by incorporating total carbon with soil moisture. As soil moisture was found to enhance rice yield on a large degree, the dryness of soil in the summer season lessened the rice production in the experimental site.