Search
Search Results
-
Behavior of Triuranium Disilicide in Water Vapor
AbstractCorrosion resistance of U 3 Si 2 in water vapor is insufficient and increases due to fragmentation caused by formation of the hydride phase. In...
-
Water vapor condensation prevention and risk rating evaluation based on Yang Can’s tomb
Temperature and humidity variations in burial stone relics can easily cause water vapor condensation, which is an important factor leading to their...
-
Impact of High Temperature and Water Vapor on the Oxidation Behavior of Chemical Vapor Infiltration-SiCf/SiC Composite
SiC f /SiC composites are replacing superalloy components in hot sections of gas turbines. The high-velocity combustion gases in gas turbine hot...
-
Oxidation in Water Vapor of Inconel 625 Fabricated by Additive Manufacturing
The high-temperature oxidation characteristics of Inconel 625 superalloy fabricated by additive manufacturing were studied at 900 and 1000 °C in a...
-
Effect of water vapor on the oxidation behavior of Al2Zr alloys
To reveal the effects of water vapor on the oxidation mechanism of Al–Zr-based materials, the Al 2 Zr alloy was oxidized in a wet atmosphere. Water...
-
Effect of Mo Addition and Water Vapor on the High-Temperature Corrosion Performance of APS Ni-Al-based Coatings
To investigate the influence of Mo addition and water vapor content on the high-temperature corrosion resistance of Ni-Al-based coatings, 0Mo, 5Mo,...
-
Effect of Oxygen on Water Vapor Oxidation of Fe by Oxygen Partial Pressure Control Using Gas Sensor
An oxygen pump sensor was installed in front of an oxidation furnace to supply and discharge oxygen to the Ar–H 2 O atmosphere and accurately control...
-
Fabrication of SPPEK-P/PPBES composite membranes for water vapor/N2 separation at high temperature
Sulfonated poly(phthalazinone ether ketone) containing pendant phenyl moieties (SPPEK-P)/copoly(phthalazinone biphenyl ether sulfone) (PPBES) thin...
-
Effect of Water Vapor and Oxygen Partial Pressure on Oxidation of Fe and Fe–Cr Alloys
Pure iron and binary Fe–Cr alloys containing 5–30 wt% Cr were exposed to Ar-20O 2 , Ar-20H 2 O and Ar-20O 2 -20H 2 O (vol%) for 10, 100 and 300 h at 700 °C....
-
Ultrathin skin-conformable electrodes with high water vapor permeability and stretchability characteristics composed of single-walled carbon nanotube networks assembled on elastomeric films
Herein, we report on conductive ultrathin films (nanosheets) with the characteristics of stretchability and water vapor permeability for...
-
Heat Resistance of Zr–1Nb Alloy Claddings in Water Vapor after Ion-Plasma Nitriding
The influence of ion-plasma nitriding time of Zr–1Nb alloy fuel cladding tubes on their resistance to oxidation in water vapor at 600–1200°C was...
-
Integrated molten and vapor condensation of polymeric carbon nitride photoelectrode towards efficient water splitting
Polymeric carbon nitride (PCN) has received extensive attention in suspension photocatalysis, whereas the preparation of high-quality PCN film is...
-
Modeling of the Temperature Profile When Heating Fuel Oil with Water Vapor in a Single-Pass Tubular Heat Exchanger
Heat exchange equipment of various types makes up a significant part of technological equipment in the gas and petrochemical industries. This is...
-
Water vapor plasma-assisted low-temperature bonding of cyclo-olefin polymer for microchannel with integrated leak detector
Cyclo-olefin polymer (COP) has attracted much attention as substrate material for microfluidic devices because of its excellent optical properties,...
-
High Temperature Corrosion in Water Vapor of Fe–2.25Cr–0.54Mo Coated with Ni-Based Alloy Containing WC–Co Using an HVOF Spraying Technique
The high temperature corrosion of Fe-2.25Cr-0.54Mo steel coated with WC–Co/NiCrFeSiB using a high-velocity oxy-fuel spraying technique was...
-
Surface passivation of α-Al2O3 powder using water vapor to achieve consistent slurry viscosity
Based on the significant viscosity variations in the aqueous α-Al 2 O 3 slurries depending on the powder pre-treatments and slurry retention, this study...
-
Thermochemical Stability of Yb2Si2O7 Environmental Barrier Coatings During Thermal Cycling and Water Vapor Corrosion at 1350 °C
In this study, Si/mullite/Yb 2 Si 2 O 7 trilayer environmental barrier coatings (EBCs) were prepared by atmospheric plasma spraying. The thermochemical...
-
Preparation of high specific surface area activated carbon fiber by high-temperature vacuum activation and its superior water vapor adsorption for air humidity control
Activated carbon fiber (ACF) with a high specific surface area has a good application prospect in atmospheric humidity control because it can adsorb H
-
Mesoporous silica particle embedded polyethylene films with enhanced oxygen and water vapor transmission rates for keep-freshness packaging
Mesoporous silica particles (MSPs) and polyethylene (PE) embedded films were prepared for better performance in extending the shelf life of products...
-
Synthesis and characterization of poly(butanediol sebacate-butanediol) terephthalate (PBSeT) reinforced by hydrogen bond containing amide group, with good mechanical properties and improved water vapor barrier
A PBSeT copolyester was synthesized by introducing a polar amide unit into the molecular chain, coordinating with decyldiamine through hydrogen bonds...
