Skip to main content

previous disabled Page of 2
and
  1. No Access

    Article

    Chemical synthesis of manganese ferrite thin films for energy storage application

    For the first time, simple chemical bath deposition method was used for the deposition of manganese ferrite (MnFe2O4) thin films on stainless steel substrate. The X-ray diffraction study showed cubic spinel cryst...

    R. P. Bhosale, S. S. Kumbhar, P. P. Bagwade in Journal of Materials Science: Materials in… (2023)

  2. No Access

    Article

    Effect of Long-Term Exposure on Microstructure and Hardness of Aged Haynes 282 Alloy

    Nickel-based superalloy, Haynes 282, is a promising material for aero and land-based gas turbine applications and advanced ultra-supercritical (AUSC) steam power plants due to its outstanding combination of hi...

    G. Damodhar Naidu, G. V. S. Nageswara Rao in Metallography, Microstructure, and Analysis (2023)

  3. No Access

    Article

    Effect of gamma-ray irradiation on structural and optical property of WSe2 film

    In the present work, RF sputtering synthesis method is used for the synthesis of tungsten diselenide (WSe2) films. These WSe2 films were studied using X-ray diffraction (XRD), Raman spectroscopy, X-ray photoelect...

    P. T. Kolhe, S. N. Dalvi, Y. V. Hase in Journal of Materials Science: Materials in… (2023)

  4. No Access

    Article

    Ratcheting Fatigue Behavior of Modified 9Cr–1Mo Steel at Room Temperature

    Fusion reactor components undergo asymmetric cyclic loading,that leads to a progressive increase in plastic strain and causes deterioration in life of engineering components. This investigation deals with fati...

    Prerna Mishra, R. S. Rajpurohit in Metals and Materials International (2021)

  5. No Access

    Article

    Studies on structural, spectral and morphological properties of co-precipitation derived Co-doped ZnO nanocapsules for NO2 sensing applications

    Pristine and Co-doped ZnO (CZ) nanocapsules (NCs) have been successfully prepared using a simple and cost-effective co-precipitation method. The effect of 1–4 at.% Co-doped ZnO (C1Z–C4Z) samples on physicochemica...

    V. S. Kamble, Y. H. Navale, V. B. Patil in Journal of Materials Science: Materials in… (2021)

  6. No Access

    Article

    Enhanced NO2 gas sensing performance of Ni-doped ZnO nanostructures

    Pure and 1–4 at.% Ni-doped ZnO (N0Z-N4Z) nanostructures have been successfully prepared by simple and cost-effective co-precipitation method. The prepared nanostructures were studied using XRD, FESEM, HRTEM, EDX,...

    V. S. Kamble, Y. H. Navale, V. B. Patil in Journal of Materials Science: Materials in… (2021)

  7. No Access

    Article

    Supercapacitive Performance of Lithium Doped and Undoped NiFe2O4 Thin Films by Chemical Deposition Method

    Lithium (Li) doped and undoped NiFe2O4 thin films for supercapacitor application have been prepared through the chemical deposition method. The Li doped and undoped NiFe2O4 thin films for structural, morphologica...

    V. S. Jamadade, P. K. Pagare, Dhanshri S. Gaikwad in Journal of Electronic Materials (2019)

  8. No Access

    Article

    Stress Corrosion Cracking of a Maraging Steel Shear Bolt Used in the Interstage Structure of a Satellite Launch Vehicle

    M250 grade maraging steel is used widely in satellite launch vehicle structures due to its excellent combination of strength and toughness. One of the maraging steel bolts used in interstage structures was fou...

    Sushant K. Manwatkar in Metallography, Microstructure, and Analysis (2016)

  9. No Access

    Article

    Fabrication of Ni0.4Zn0.6Fe2O4–BaTiO3 bilayered thin films obtained by spray pyrolysis method for magnetoelectric (ME) effect measurement

    The Ni0.4Zn0.6Fe2O4 ferrite, BaTiO3 ferroelectric and Ni0.4Zn0.6Fe2O4–BaTiO3 bilayered magnetoelectric thin films have been synthesized onto the quartz substrates at optimized substrate temperatures (400, 250 °C)...

    S. S. Kumbhar, M. A. Mahadik, V. S. Mohite in Journal of Materials Science: Materials in… (2016)

  10. No Access

    Article

    Photoelectrocatalytic degradation of methyl blue using sprayed WO3 thin films

    WO3 thin films have been deposited using simple chemical spray pyrolysis technique and successfully applied as photoanode for photoelectrocatalytic degradation of methylene blue. The films were deposited on bare ...

    Y. M. Hunge, M. A. Mahadik, V. S. Mohite in Journal of Materials Science: Materials in… (2016)

  11. No Access

    Article

    Photoelectrocatalytic degradation of methyl red using sprayed WO3 thin films under visible light irradiation

    WO3 thin films have been deposited onto glass and FTO coated glass substrates using simple chemical spray pyrolysis technique. The effect of solution concentration on the photoelectrochemical (PEC), structural, m...

    Y. M. Hunge, V. S. Mohite, S. S. Kumbhar in Journal of Materials Science: Materials in… (2015)

  12. No Access

    Article

    Evaluation of the Competitiveness of Wall Building Materials with Glassy Protective-Decorative Coatings Obtained by Plasma Fusing

    The results of research on the development of a desirability scale for evaluating the competitiveness of wall building materials with glassy protective-decorative coatings obtained by plasma fusing are present...

    V. S. Bessmertnyi, N. I. Min’ko, N. I. Bondarenko, A. V. Simachev in Glass and Ceramics (2015)

  13. No Access

    Article

    Sulfidation Characteristics of an Advanced Superalloy and Comparison with Other Superalloys Intended for Gas Turbine Use

    Sulfidation may occur even in an overall oxidizing environment beneath a corrosion product which assumes the role of a diffusion barrier allowing sulfur species transport at a faster rate when compared with th...

    I. Gurrappa, I. V. S. Yashwanth in Metallurgical and Materials Transactions A (2013)

  14. No Access

    Article

    Synthesis and characterization of cobalt–nickel alloy nanowires

    We report on the synthesis and magnetic characterization of ordered arrays of cobalt–nickel alloy nanowires. These alloy nanowires were electrodeposited into the pores of anodic alumina templates. The physical...

    S. Talapatra, X. Tang, M. Padi, T. Kim, R. Vajtai in Journal of Materials Science (2009)

  15. No Access

    Article

    Work-Hardening Behavior of the Ni-Fe Based Superalloy IN718

    Flow behavior of many metals and alloys in the region of uniform plastic strain is normally expressed by the simple power law relationship (σ = Kε p ...

    K.V.U. Praveen, G.V.S. Sastry, Vakil Singh in Metallurgical and Materials Transactions A (2008)

  16. No Access

    Article

    Charge transfer at the antiscale composite layer-electrolyte interface

    Properties of composite coatings based on oxide layers formed on a titanium surface using the plasmic electrolytic oxidation method and processed using Forum® superdispersed polytetrafluorinethylene were inves...

    S. V. Gnedenkov, S. L. Sinebryukhov, D. V. Mashtalyar in Protection of Metals (2007)

  17. No Access

    Article

    Poly(vinyl pyrolidone) coated silver nano powder via displacement reaction

    P. K. Khanna, R. Gokhale, V. V. V. S. Subbarao in Journal of Materials Science (2004)

  18. No Access

    Article

    Nature of the interface between AA7072 alloy explosively clad to AA8090 aluminium alloy

    Aluminium-lithium based alloy plates were explosively clad with Al-1 wt% Zn alloy sheets. Clad plates were evaluated for bond continuity, interface shape, microstructure, variation of elemental concentrations ...

    P. Mallesham, A. A. Gokhale, V. S. R. Murti in Journal of Materials Science (2003)

  19. No Access

    Article

    CdSe : Sb electrode for photoelectrochemical applications

    CdSe : Sb thin film electrodes with Sb3+ do** concentrations from 0 to 5 mol % were prepared in an aqueous alkaline medium (pH≈10) by a solution-growth technique. Use of these films was made as an active photoe...

    E. U. Masumdar, L. P. Deshmukh, S. H. Mane in Journal of Materials Science: Materials in… (2003)

  20. No Access

    Article

    Use of cermet filters for purifying samples of open-hearth furnace flue gases

    1. A method has been successfully worked out for purifying samples of flue gas by cermet filters under high temp...

    I. M. Fedorchenko, M. I. Korobko in Soviet Powder Metallurgy and Metal Ceramics (1965)

previous disabled Page of 2