Abstract
Plenty of experiments and data analysis of vehicle track type in road curved section show that the deviation and the crossing characteristics of vehicle track paths are directly related to the driving stability and security. In this paper, the concept of driving dangerous area in curved section was proposed based on the vehicle track characteristics according to driving behavior decision making and accident probability. Taking the observation data of passenger cars as the representative, the vehicle track paths deviation regularity per measurement direction were analyzed by SPSS under the condition of different radius and different road cross section. The distribution probability of different track type and the accident probability calculation methods and results between opposite direction vehicles were given based on the track characteristics.
Article PDF
Avoid common mistakes on your manuscript.
References
J. D. Lee, Fifty Years of Driving Safety Research, Human Factors and Ergonomics Society, 50(3) (2008), 521–528.
G. Zhou, Analysis of Influencing Factors on Freeway Traffic Safety and Fuzzy Comprehensive Evaluation, M. S. Thesis (in Chinese), Southwest Jiaotong University, (2004)
Y. Y. Wang, Research on the Accident Causations of Mountainous Road, M. S. Thesis (in Chinese), Bei**g University of Technology, (2008)
I. L. Thomas and W. T. Taylor, Effect of Edge Stri** on Traffic Operations, Highway Research Board Bulletin, 244(1960), 11–15.
X. D. Sun, Impact of Edge Lines on Safety of Rural Two-Lane Highways. Civil Engineering Department University of Louisiana at Lafayette, (2005)
P. Spacek, Track Behavior and Accident Occurrence in Curves on Two-lane Highways in Rural Areas. 2nd International Symposium on Highway Geometric Design, (2000), 288–298
P. Spacek, Track Behavior in Curve Areas: Attempt at Typology, Journal of Transportation Engineering, 131(9) (2005), 669–677
E. Donges, A two level model of driver steering behavior, Human Factors, 20(6) (1978), 691–707.
A. Garcia and E. Diaz, Vehicle Tracking in Black Spots Using Artificial Vision Techniques in Order to Improve Road Geometric Design Standards, International Symposium on Highway Geometric Design Practices, (E-C003) (1998), 38:1–6
H. Feng, Research on the Establishment of Traffic Signs and Marking in Two-lane Mountain Highway, M. S. Thesis (in Chinese), Jilin University, (2007)
R. Krammes, R. Brackett, et al, Horizontal Alignment Design Consistency for Rural Two-Lane Highways, Federal Highway Administration Report, (Washington, D. C. 1995)
M. Islam and P. Seneviratne, Evaluation of Design Consistency of Two-Lane Rural Highways, ITE Journal, 64(02) (1994), 28–31
J. C. Glennon and G. D. Weaver, The Relationship of Vehicle Paths to Highway Curve Design. (Texas Transportation Institute, 1971)
B. Liu, Mechanism Study on the Vision-based Speed Control and lane Kee**, M. S. Thesis (in Chinese), Wuhan University of Technology, (2008)
J. Xu, Effects of Change in Road Geometry Design on Vehicle Driving Dynamics, M. S. Thesis (in Chinese), South Jiaotong University, (2010)
T. Lin, Vehicle Acceleration and Driving Track Research of Sharp Curves in Mountainous Highway, M. S. Thesis (in Chinese), Tongji University, (2008)
Z. Yang, Research on Driving Dynamic Simulation Model, Ph. D. dissertation (in Chinese), Tongji University, (2004)
D. H. Wang, Traffic Flow Theory, (China Communications Press, China, 2002)
Y. Y. Ren, X. S. Li, Study on distribution characteristics of dangerous driving area in curved section based on human-vehicle operation characteristics, 2010 IEEE International Conference on Emergency Management and Management Sciences (ICEMMS), (2010), 189–193
S. Upadhyaya, A. Arora and R. Jain, Reduct Driven Pattern Extraction from Clusters, International Journal of Computational Intelligence Systems(IJCIS), 2(1) (2009), 10–16
A. Assenza, M. Valle, M. Verleysen, A Comparative Study of Various Probability Density Estimation Methods for Data Analysis, International Journal of Computational Intelligence Systems(IJCIS), 1(2) (2008), 188–201
Wuhong Wang,Wei Zhang,Hongwei Guo,Heiner Bubb,Katsushi Ikeuchi, A safety-based behavioural approaching model with various driving characteristics, Transportation Research Part C-Emerging Technologies, doi:10.1016/j.trc.2011.02.002.
Wuhong Wang, Qi Cao, Katsushi Ikeuchi, Heiner Bubb, Reliability and safety analysis methodology for identification of drivers’ erroneous actions, International Journal of Automotive Technology, 2010 11(6),873–881.
Wuhong Wang, Yan Mao, ** **g, ** model, International Journal of Computational Intelligence Systems,2011 4(3),297–305.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
About this article
Cite this article
Ren, Yy., Li, Xs., Ren, Y. et al. Study on Driving Dangerous Area in Road Curved Section Based on Vehicle Track Characteristics. Int J Comput Intell Syst 4, 1237–1245 (2011). https://doi.org/10.2991/ijcis.2011.4.6.15
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.2991/ijcis.2011.4.6.15