Abstract
In this study, trifluoroiodomethane (CF3I), a non-global-warming gas, has been investigated as a substitute for typical PFC’s currently used in wafer patterning and CVD chamber cleaning processes. Dielectric films consisting of plasma enhanced chemically vapor deposited silicon dioxide and silicon nitride were comparatively etched in CF3I and C2F6/O2 plasma environments. The etch rate of these films was ascertained as a function of applied rf power, etchant gas flow rate, reaction chamber pressure, and CF3I: O2 ratio. Destruction efficiencies of CF3I at different processing parameters were evaluated. Depending on the flow rate, rf power, and chamber pressure, utilization efficiency of CF3I varied from as low as 10% to as high as 68%. CF4, C2F6, COF2, and CO2 were the predominant by-products found in the exhaust stream; however, their concentrations were very low compared to the traditional process employing C2F6/O2 mixtures.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Intergovernmental Panel on Climate Change, Radiative Forcing of Climate Change—The 1995 Report of the Scientific Assessment Working Group of the IPCC (1995).
A. R. Ravishankara, S. Solomon, A. A. Turnipseed, and R. F. Warren, Science 259, 196 (1993).
P. Maroulis, J. Langan, A. Johnson, R. Ridgeway, and H. Withers, Semicond. Int. 11, 107 (1994).
S. M. Karecki, B. A. Tao, and R. Reif, Proceedings of SRC Techcon 1996 Conference, Phoenix, AZ (September 1996).
P. Mahal, “C3F8 Etch Process Development Report,” Novellus Systems, Inc. (unpublished report, July 1995).
B. Bryant, Schumacher, CA (unpublished report, 1996).
R.E. Tapscott, S. R. Skaggs, and D. Dierdorf, in Halon Replacements: Technology and Science, edited by W. Tsang and A. W. Miziolek (ACS Symposium Series, 1995), Vol. 611, p. 14.
S. Solomon, J.B. Burkholder, A. R. Ravishankara, and R. R. Garcia, J. Geophys. Res. 99, 20,929 (1994).
R.A. Levy, J. M. Grow, Y. Yu, and K. T. Shih, Mater. Lett. 24, 47 (1995).
R.A. Levy, L. Chen, J.M. Grow, and Y. Yu, Electrochem. Soc. Proc. 96-1, 1059 (1996).
R.A. Morgan, Plasma Etching in Semiconductor Fabrication (Elsevier, New York, 1985).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Levy, R.A., Zaitsev, V.B., Aryusook, K. et al. Investigation of CF3I as an Environmentally Benign Dielectric Etchant. Journal of Materials Research 13, 2643–2648 (1998). https://doi.org/10.1557/JMR.1998.0368
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/JMR.1998.0368