Conclusions
A method has been developed for pressing of parts varying in thickness, including plates for slide valves, for the purpose of uniform distribution of density. A high degree of compaction of the zone of the steel teeming hold of the part is obtained by pressing of plates with an insert corresponding to the projecting portion.
The specific wear of the hole in the experimental corundum plates in service is 2.36 times less than in the plates pressed by the normal method.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
V. G. Abbakumov, M. S. Glazman, I. Yu. Khlebnikova, et al., Ogneupory, No. 1, 12–19 (1979).
K. V. Simonov, E. P. Mezentsev, and V. P. Chernyavskaya, Byul. Nauch. Tekh. Inf. Chernaya Met., No. 19, 36–38 (1976).
V. E. Vernikovskii, Ogneupory, No. 2, 30–34 (1980).
I. F. Usatikov, I. G. Shulik, T. G. Gal'chenko, et al., Metallurg. Gorn. Promysh., No. 2, 36–37 (1980).
Author information
Authors and Affiliations
Additional information
Translated from Ogneupory, No. 12, pp. 13–15, December, 1983.
Rights and permissions
About this article
Cite this article
Evich, L.I., Kalita, G.E. & Shulik, I.G. A method of compacting slide valve plates in pressing. Refractories 24, 612–614 (1983). https://doi.org/10.1007/BF01435714
Issue Date:
DOI: https://doi.org/10.1007/BF01435714